Preparation and Properties of Bromochlorinated Butyl Rubber

Qiao-long YUAN,Gang QI,Feng LIU,Qing LIU

DOI: https://doi.org/10.3969/j.issn.1006-3080.2014.02.004

2014-01-01

Abstract:Butyl rubber was chlorinated to form chlorinated butyl rubber(CIIR)in non-intermeshing counter-rotating twin-screw extruder,and further brominated in hexane solution by liquid bromine at 80 ℃.Bromochlorinated butyl rubber(BCIIR)was obtained and characterized by proton nuclear magnetic resonance,thermal gravimetry and rotorless curemeter.Results show that CIIR with the mass fraction of chlorine 1.1%is prepared by chlorination extrusion process.Secondary chloro allylic structure in CIIR is facile to achieve when the temperature of chlorination extrusion is in the range of 100—110 ℃. Furthermore,a small amount of isoprene structure is still in CIIR.The mass fraction of bromine in BCIIR is in the range of 0.2%—0.8%,and increases upon the increasing of the amount of liquid bromine.The bromination of CIIR results in decrease of weight-average molecular weight and unsaturation degree of the rubber.However,the unsaturation degree of CIIR retains about 1.2%.The thermal stability of CIIR is improved with bromination.The thermal decomposition temperature of BCIIR is higher than that of CIIR, and enhances with the increase of mass fraction of bromine.The rate of vulcanization of BCIIR expedites markedly,which is 5% higher than that of CIIR,and 14% higher than that of butyl rubber.