Solidification process of hollow metal droplets impacting a substrate
Tao An,Hao Chen,Xianqian Sang,Yuchen Wang,Haisheng Fang
DOI: https://doi.org/10.1016/j.icheatmasstransfer.2024.108252
IF: 6.782
2024-10-25
International Communications in Heat and Mass Transfer
Abstract:Recently, there has been a renewed interest in hollow droplet impact, as the internal bubble makes a difference in the spreading morphology during thermal spraying and three-dimensional printing. This paper is dedicated to the solidification process of a hollow metal droplet impacting a cold substrate. The influence of initial impact velocity and substrate temperature on the spreading process is numerically investigated by employing a phase-field method coupled with a solidification model. Solidification was shown to strongly alter droplet spreading and the flow state of the center liquid column. To describe the flow state of the center liquid column, three patterns, namely 'no-jet', 'transition region', and 'counter-jet' are defined. The simulation results show that the formation of the center counter-jet is inhibited by the solidification layer when Péclet number Pe<357 , where Pe is the ratio of convection rate to diffusion rate. In addition, the critical Pe at which the phenomenon of counter-jet occurs gradually rises with the substrate temperature falling. Finally, a quantitative analysis of the maximum spreading diameter is proposed by establishing an energy conservation equation. The predicted diameters are in good agreement with the simulated results. It allows us to provide a general expression for the hollow droplets' maximum spreading diameter, using the impact and temperature parameters.
thermodynamics,mechanics