Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Review and outlook of study on gas flow noise of rotating compressors

Review and outlook of studying on noise of centrifugal pumps

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

Numerical Analysis of Noise Radiation from Refrigerator Compressor Shell

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Numerical analysis of the influence of lubrication oil on noise radiation of compressor shell

A Review of the Flow-Induced Noise Study for Centrifugal Pumps

Analysis and Suppression of Gas Flow Noise from the Accumulator of Rotary Compressor

Simulation and experimental research on aerodynamic noise of gas turbine 1.5-stage axial compressor

Investigation on the Pressure Pulsation in the Discharge Muffler of Rotary Compressors

Analysis of Vibration and Noise Induced by Unsteady Flow Inside a Centrifugal Compressor

Study On Acoustic Performance Of A Water Muffler For Gear Pump

Simulation research on aerodynamic noise characteristics of a compressor under different working conditions

Vibro-acoustics of a Pipeline Centrifugal Compressor Part I. Experimental Study

Improvement on Acoustic Performance of the Accumulator of Double-Cylinder Rotary Compressors

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Flow Field Noise Analysis and Noise Reduction Research of Twin-Screw Air Compressor Based on Multi-Field Coupling Technology

Study of the Discharge Pressure Pulsation Within Twin Screw Compressors

Study of Aerodynamic Noise in Hermetic Refrigerator Compressor

Review of the Noise Control of Hermetic Refrigerator Compressor

Experimental and numerical study of high-intensity sound in the cavity between rotator and stator of high- pressure compressor