Abstract:The influence of surface microstructural regulation mechanisms on the mechanical and giant magneto-impedance (GMI) properties of as-cast melt-extracted CoFe-based wires has been systematically researched based on morphology, phase distribution and domain structure parameters. A series of statistical models were applied to analyze the mechanical properties and followed by mapping the curve of cumulative failure rate for wire application. It was found that the average and highest fracture strengths, average tensile strain increased with Cu substitution and reached peaks of ~3725 MPa, ~4250 MPa and ~2.7%, respectively. Verified structure-simulation experiments revealed that surface Rayleigh waves effectively split the main crack and the diffusely distributed nanocrystalline in surface area acted as a pinning point to impede the crack growth, enhancing the mechanical properties. The GMI ratio displayed similar variations and attained a maximum value of 700 ± 5% as well as the resistance and reactance ratios improved to ~687% and ~2206%, respectively. The enhanced relative dielectric permeability μs resulting from the increased domain wall energy density and the decreased surface domain width. The unique synchronous enhancement of CoFe-based wires satisfies the demand for emerging magnetoelectric sensor applications, e.g. flexible and wearable sensors, equipment self-monitoring sensors, and array robotic skin sensors under harsh working environments.

Effect of pH on the Giant Magneto-impedance Properties of Cu/CoNiP Composite Wires prepared by Chemical Deposition

Optimized GMI Effect in Electrodeposited CoP/Cu Composite Wires

Influence of Fe Doping and FeNi-layer Thickness on the Magnetic Properties and GMI Effect of Electrodeposited Ni100−xFex/Cu (x= 0–95) Wires

Investigation of giant magneto-impedance effect in electroless-deposited CoP/Insulator/BeCu wires

Large Enhancement of Gmi Effect in Polymer Composites Containing Co-Based Ferromagnetic Microwires

The Giant Magneto-Impedance Effect and Frequency Dependence of Magnetization Processes in Nifecop/Becu Composite Wire

Study of the Giant Magnetic Impedance Effect in Electro-depositied Complex Wire

Composite electroplating to enhance the GMI output stability of melt-extracted wires

Electroless Deposition of Ni-Co-P Deposit on NdFeB Permanent Magnets and Its Corrosion Resistance Property

Investigation of Giant Magneto-Impedance Effect in CoP/Insulator/BeCu Microwire Resonator

Length Effect on Giant Magneto-Impedance in Glass-Covered Co-rich Amorphous Wire

Large GMI effect in Co-rich amorphous wire by tensile stress

The Effect of Magnetic Field on CoNiFe/Al2O3 Composite Coating Properties Prepared by Electrodeposition

Magnetization Property and Magneto-Impedance of Dc Joule Annealed CuBe/insulator/NiCoP Composite Wire

Combined Current-Modulation Annealing Induced Enhancement Of Giant Magnetoimpedance Effect Of Co-Rich Amorphous Microwires

Influence of the bath pH value on the microstructure and properties of a novel electrodeposited Ni-W-Ti3C2TX composite coating

Study of the Lc Resonance Giant Magneto-Impedance Effect

Magnetoimpedance of LC Resonance Composite Wires with Insulator by Electroless-Deposited

Effect of Deposition Parameters on the Structure of ZnCo Alloy Nanowires and Growth Mechanism

Giant Magneto-Impedance Effect on Nanocrystalline Microwires with Conductive Layer Deposit

Surface microstructural design to improve mechanical and giant magneto-impedance properties of melt-extracted CoFe-based amorphous wires