Abstract:Objective:To investigate the biomechanical effect of osteoporosis on sacral pedicle screws instru-mentation.Method:25 fresh adult human sacra specimen featuring osteoporosis were used in this study.Accord-ing to the value of lumbar bone mineral density(BMD) assessed by a dual energy X-ray absorptiometry, specimens were assigned into three groups as follows,group A(n=9),BMD 0.70-0.79g/cm2,group B(n=8),BMD 0.60-0.69g/cm2,group C(n=8),BMD<0.60g/cm2.For each specimen,S1 pedicle screw was inserted bicortically on the left side,and S1 pedicle screw augmented by polymethylmethacrylate(PMMA) was inserted unicortically on the contralateral side of sacrum.Following a dynamic cyclic loading from 30N to 250N on the screw head for 2000 cycles,the subsidence displacement and axial pull-out strength of each screw were measured,and we defined subsidence displacement over 2mm after 2000 cyclic loading as anchoring failure.Result:No anchoring failure was noted in both group A and B.However,in group C,6 cases(75%) in bicortical fixation and 5 cas-es(63%) in PMMA augmented fixation had evidence of failure during cyclic loading.In group A,no significant difference between bicortical and PMMA augmented fixation was detected in terms of the subsidence displace-ment and maximal screw pull-out strength(P>0.05).In group B,significantly less subsidence and higher maxi-mal screw pull-out strength were documented in the PMMA augmentation than that in bicortical fixation(P< 0.05).Both techniques in group A exhibited lower subsidence of the screw than that in group B(P<0.05).Bi-cortical technique in group A exhibited higher maximum pull-out strength than that in group B(P<0.05).How-ever,statistical difference in terms of PMMA augmentation was not detected between group A and B(P>0.05).Among the cases with anchoring failure in group C,significantly more loading cycles(before failure) were ob-served in PMMA augmented unicortical fixation than that in bicortical fixation .Conclusion:For BMD ≥ 0.70g/cm2,bicortical sacral pedicle screw fixation could obtain sufficient anchoring strength compared to that provide by PMMA augmented technique.When BMD is 0.60-0.69g/cm2,PMMA augmented technique have more pull-out screw strength than bicortical fixation.For BMD<0.60g/cm2,early screw loosening may occur in both bicortical and PMMA augmented fixations.Therefore,preoperative evaluation of lumbar BMD is critical to choose a appropriate technique for sacral screw instrument.

A Study on the Effect of Bone Mineral Density on the Failure Load of the Lumbar Endplate

The Effect of Disc Height and Degeneration on the Mechanical Behavior of Lumbar Spine:A Finite Element Analysis

Endplate Concavity Variation of Lumbar Motion Segments a Finite Element Analysis

The Osseous Endplates in Lumbar Vertebrae: Thickness, Bone Mineral Density and Their Associations with Age and Disk Degeneration.

Bone mineral density and bone mineral content in the lumbar vertebrae and the vetebra's biomechanical properties

Finite element analysis into the effect of discectomy on lumbar biomechanical characteristics

[Analysis of Lumbar Disc Degeneration Using Three-Dimensional Nonlinear Finite Element Method].

A morphological study of lumbar vertebral endplates: radiographic, visual and digital measurements

[The Feature of Experimental Endplate Fracture in Lumbar Spine and Its Related Factors].

Relationship of Vertebral Body Bone Mineral Density with Insertional Torque and Pull-out Strengths of Pedicle Screws and Its Clinical Significance

Effect of lumbar nerve dorsal roots section on the rat bone structural changes of lower limb

Biomechanical properties of lumbar endplates and their correlation with MRI findings of lumbar degeneration

Comparison among bone mineral density of vertebra and volume and intensity of biomechanics

The correlation between bone mineral density and surgical outcomes of lumbar degenerative spondylolisthesis

Biomechanical Effect of Bone Cement Volume and Distribution on Lumbar Vertebral Body with Osteoporotic Fracture

Vertebral Endplate Defects Are Associated with Bone Mineral Density in Lumbar Degenerative Disc Disease

STRESS AND STRAIN ANALYSIS OF THE END-PLATE OF THE LUMBAR SPINE WITH DEGENERATED DISC AND OSTEOPOROSIS UNDER COMPRESSION LOADING

Biomechanical effect of osteoporosis on sacral pedicle screws instrumentation

Biomechanical Analysis of Lumbar Interbody Fusion Cages with Various Elastic Moduli in Osteoporotic and Non-osteoporotic Lumbar Spine: A Finite Element Analysis.

The relationship between bone strain index, bone mass, microarchitecture and mechanical behavior in human vertebrae: an ex vivo study

THE MECHANICAL RESEARCH ON INTRAVERTEBRAL BODY DEFECT AND ITS CLINICAL SIGNIFICANCE