Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

The encement of the diajet system on the structure and performance

Experimental investigation on carbon deposition characteristics of aeroengine swirl nozzle and its effect on spray behaviors

Ensuring the Abrasive Jet Machining Efficiency Using a Nozzle with a Perforated Insert

Research on the structures and hydraulic performances of the typical direct jet nozzles for water jet technology

Improvement of process repeatability and resolution in abrasive air jet machining via viscous slurry entrainment

Multiphase flow and nozzle wear with CFD-DEM in high-pressure abrasive water jet

Investigation of influencing factors of wear in a sandblasting machine by CFD-DEM coupling

Surface removal of ductile metal using cyclic low-frequency impact of a discrete particle-less waterjet

Nozzle Wear in Abrasive Water Jet Based on Numerical Simulation

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

A Novel Technique for Dressing Fixed Abrasive Lapping Pad with Abrasive Water Jet

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Analysis of gas-solid two-phase flow and structure optimization of mobile shot blasting machine recovery device

Internal mixing chamber flow field of a premixed abrasive water jet descaling nozzle

Research on the dust-control technology of a double-wall attached-ring air curtain on an excavation face

Aggressive ability improvement of self-resonating cavitating jets with double-hole nozzle

Analysis on spray behavior of ducted fuel injection under different ambient pressures

Study on the key parameters of ice particle air jet ejector structure

Effects of structural parameters of pressure-swirl nozzle on atomization and dust removal characteristics

Experimental investigation of internal and external flow fields of jetting nozzles with different structures

Effect of Anode Structure on the Performance of Arcjet