Abstract:A phosphorus removal biochar adsorbent was prepared from Fenton sludge. The adsorption process was optimized, and its phosphorus adsorption mechanism was discussed. It was found that the phosphorus adsorption performance of biochar prepared from single Fenton sludge (FBC-400) was better than that of co-pyrolysis of Fenton sludge and bamboo powder. The optimum condition was that Fenton sludge pyrolyzed at 400 degrees C (FBC-400). FBC-400 had a larger specific surface area than that prepared by co-pyrolysis with bamboo powder. And the high content of iron element could provide a higher surface charge of the biochar, thereby increasing the electrostatic adsorption of phosphorus onto FBC-400. The phosphorus adsorption was highly pH dependent by FBC-400, which can enhance electrostatic adsorption and increase adsorption capacity in acidic conditions. The effect of coexisting anion on adsorption performance was mainly affected by CO32-, reducing the adsorption capacity by at least 49%, whereas other anions had no obvious interference. The adsorption process of FBC-400 accorded with the pseudo-second-order kinetic model and the Langmuir model, which indicated that the adsorption process was monolayer adsorption and mainly chemical adsorption, and the maximum saturated phosphorus adsorption capacity was 8.77 mg g(-1). The mechanisms for phosphorus adsorption were electrostatic adsorption and inner-sphere complexing. 1 M NaOH was used for desorption, and the adsorption capacity remained at 81% in the fifth cycle. Practitioner Points The Fenton sludge biochar usage as an adsorbent could be a win-win strategy to convert waste biomass to valuable - product. The adsorption process accorded with the Langmuir model, the maximum phosphorus adsorption capacity was 8.77 mg/g at 25 degrees C. The adsorption mechanisms were electrostatic adsorption and inner-sphere complexing. 1M NaOH was used for desorption, and the adsorption capacity remained at 81% in the fifth cycle.

Phosphorus Removal from Wastewater by Adsorption on Blast Furnace Slag

Phosphorus Removal from Wastewater Using Electric Arc Furnace Slag Aggregate

Mechanisms of Phosphate Removal from Aqueous Solution by Blast Furnace Slag and Steel Furnace Slag

Facile preparation of dual La-Zr modified magnetite adsorbents for efficient and selective phosphorus recovery

Remove and Recover Phosphorus During Anaerobic Digestion of Excess Sludge by Adding Waste Iron Scrap

Removal of phosphate from wastewater using coal slag

Chimeric classical swine fever (CSF)-Japanese encephalitis (JE) viral replicon as a non-transmissible vaccine candidate against CSF and JE infections.

Phosphate Removal from Solution Using Steel Slag Through Magnetic Separation

Performance and mechanism of phosphorus removal by slag ceramsite filler

Phosphorus Removal Using Ferric–calcium Complex As Precipitant: Parameters Optimization and Phosphorus-Recycling Potential

The Phosphorus Removal Characteristics of Grain-Slag As Filter Media

Preparation of magnesium-modified steel slag and its adsorption performance for simultaneous removal of nitrogen and phosphorus from water

Phosphates Recovery through Hydroxyapatite Crystallization from Wastewater Using Converter Slag as a Seed Crystal

A Kinetic Study on Selective Leaching of Phosphorus from Dephosphorization Slag

Removal of Phosphorus Using Biochar Derived from Fenton Sludge: Mechanism and Performance Insights.

Phosphorus adsorption from aqueous solutions using different types of cement: kinetics, isotherms, and mechanisms

Separation and recovery of phosphorus from steelmaking slag via a selective leaching–chemical precipitation process

Phosphorus and nitrogen removal from water using steel slag in soil-based low-impact development systems

Phosphorus removal from aqueous solutions containing low concentration of phosphate using pyrite calcinate sorbent

Efficient extraction of phosphate from dephosphorization slag by hydrochloric acid leaching

Leaching behavior and microstructure of phosphorus in converter slag