Abstract:Hydrogen gas is an ideal fuel due to its higher calorific value among fuels and minimal environmental impact on their energy applications. However, the high cost around high reactivity, explosion risks and extremely low energy density, make it unfeasible to be used as fuel in large quantities scale. There are some possibilities to circumvent these limitations, including obtaining and converting energy through fuel cells, which is very promising. Research in this field has been summarized in recent decades, motivated by the environmental problems faced due to the dependence on non-renewable energy matrices. From this, this study aimed to improve the steam methanol reforming using CuO/ZnO/Al2O3 catalyst. The catalyst was characterized by atomic absorption spectroscopy, N2 physisorption and XRD. Catalytic tests were carried out in a laboratory scale fixed bed reactor at 300°C, atmospheric pressure and in differential conditions (methanol conversion < 10%); a previous run for catalyst synthesis validation in relation to the results obtained in the literature for the same conditions was evaluated. Subsequently, it was found that the thermal degradation of methanol at 300°C without the presence of the catalyst was negligible, and then operational conditions were established to obtain methanol conversions lower than 10%. Then, the initial deactivation of the catalyst over 31h. Also identifying the stability after 7 h in reaction with average conversion into 9.7% of methanol, showing high stability, in addition to good reproducibility on the part of synthesis in optimal composition. Then, experiments were carried out for the molar ratios 2:1 and 4:1 with methanol conversions of 15.5% and 6.6%, respectively. Note that performing the average of the 4:1 and 2:1 methanol conversion in 14.6% obtained at indicating that the upper boundary molar ratios (4:1) compensates for the conversion reduction in 2:1, achieving a result superior to the reference 3:1.

Optimization of Methanol Reactor with Decreasing Catalyst Activity

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Simulation of multi-fluidized-bed in series for methanol to olefins

A near-zero carbon emission methanol production through CO2 hydrogenation integrated with renewable hydrogen: Process analysis, modification and evaluation

Optimization of methanol production process from carbon dioxide hydrogenation in order to reduce recycle flow and energy consumption

Study on the Laws of Methanol Reforming Coupled with Flow, Heat and Mass Transfer Processes with Variable Catalyst Distribution in Microchannels

Modeling, optimization and operability analysis of Lurgi and Haldor Topsøe methanol synthesis reactors

Novel Methodology for Targeting the Optimal Reactor and Operating Parameters Based on the Chemical System’s Overall Performance Within Catalyst Lifecycle

Simulation and Analysis of the Operating Conditions of Methanol Synthesis Converter

Intrinsic Kinetics of Methanol Synthesis over a New Catalyst

Simulation and analysis of methanol synthesis reactor with the scale of 600 kt/a

Simulation and Optimization of Acetylene Converter with Decreasing Catalyst Activity

Intrinsic Kinetics of Methanol Synthesis over Catalyst XNC-98

Experimental and kinetic modelling studies for the design of fixed bed methanol reactor over CuZA catalyst

Evaluation of feeding molar rate in mini fixed bed reactor for methanol steam reforming with pre-optimized composition of CuO/ZnO/Al2O3 catalyst

One-dimensional isothermal multicomponent diffusion-reaction model and its application to methanol synthesis over commercial Cu-based catalyst

Intrinsic kinetics of methanol synthesis over catalyst SC309

Methanol production by CO2 hydrogenation: Analysis and simulation of reactor performance

Methanol Synthesis in Three-phase Agitated Reactor Using C302-2 Catalyst I. Influence of Operating Conditions on Methanol Synthesis

Apparent Kinetics of Methanol Synthesis with New Catalyst

Optimizing interfacial interaction between Cu and metal oxides boosts methanol yield in CO2 hydrogenation