Abstract:Jacket foundation is widely applied in development of offshore wind power, oil and gas. The failure of a jacket foundation is mainly caused by the lateral loads of wind, wave, current, earthquake, etc. Two groups of centrifugal model tests on a jacket foundation loaded along the border and the diagonal respectively are carried out in saturated sand to investigate the distribution of internal forces, difference of soil resistance and deformation characteristics for piles. The test results show that the piles of a jacket foundation will be pulled out more easily under diagonal loading. Moreover, compared with the up-lifted pile, the downward-pushed pile bears larger shear force and the maximum negative bending moment at the top, and larger maximum positive bending moment of the pile shaft, and shows basically the same lateral deflection. As for a 5.8-diameter spaced jacket foundation, because of the pile group effect and the up-lifting force which reduces the effective stress in soil around the pile, the resistance of shallow layer soils around the up-lifted pile is 60%of that around the downward-pushed pile within the depth of 2.5-diameter below mudline under diagonal loading, which is only 40% of that under diagonal loading. These differences of shear force, the maximum negative bending moment, axial force at the top and the maximum positive bending moment of the pile shaft between the downward-pushed pile and the up-lifted pile under diagonal loading are also more obvious than those under diagonal loading. In comparison with these results of centrifugal model tests on a large-diameter single pile under lateral loads, it is found that the soil resistance for a single pile is between that for the up-lifted pile and the downward-pushed pile of a jacket foundation at the same depth.

Centrifugal model tests and numerical simulation on bearing capacity and deformation of uplift piles with uniform sections

Lateral Bearing Performance of a Defective Pile-Supported Wharf with Batter Piles

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Centrifuge modelling on tetrapod jacket foundation subjected to lateral loads

Centrifuge Modelling for Seismic Response of Single Pile for Wind Turbine Subjected to Lateral Load

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Centrifuge model test on suction caisson foundation in soft clay subjected to lateral loads

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Centrifuge Model Tests On Vertical Bearing Capacity Of Single Pile In Silty Clay

Multi-scale study of load-bearing mechanism of uplift piles based on model tests and numerical simulations

Effects of deep excavation on uplift capacity of piles by centrifuge tests

Centrifuge Testing and Numerical Modeling of Single Pile and Long-Pile Groups Adjacent to Surcharge Loads in Silt Soil

Effects of Pile Installation Simulation on Behavior of Pile Groups in Centrifuge Model Tests

Centrifuge model tests and settlement calculation of belled and multi-belled piles in loess area

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

Centrifuge Model Tests on Super-Long Piles with Large Diameters Considering Mudcake Effect