Abstract:Previous studies on laterally loaded piles in clay have mainly focused on flexible and rigid piles. Little attention has been paid to semi-rigid piles (whose pile–soil stiffness lies somewhere between those of rigid and flexible piles), which may behave as either flexible piles or rigid piles, depending on the change in soil stiffness during cycling. This study aims to understand the cyclic lateral response of a repeatedly loaded semi-rigid pile in soft clay and the failure mechanisms of the soil around the pile, through a series of centrifuge model tests and three-dimensional finite element analyses using an advanced hypoplastic clay model. Numerical parametric studies were also performed to investigate the evolution of soil flow mechanisms with increasing pile rigidity. It is revealed that the semi-rigid pile behaved as if it were a flexible pile (i.e., flexural deformation dominated) during the first few cycles, but tended to behave like a rigid pile (i.e., rotational movement prevailed) during subsequent cycles, which progressively softened the surrounding soil. As a result, the mechanisms of soil flow around the semi-rigid pile exhibited an intermediate behaviour combining the mechanisms of both flexible and rigid piles. Three distinctive mechanisms were identified: a wedge-type mechanism near the surface, a full-flow mechanism (within the transverse sections) near the middle of the pile, and a rotational soil flow mechanism (in the vertical symmetrical plane of the pile) near the lower half of the pile. By ignoring the rotational soil flow mechanism, which has a much lower resistance than the full-flow mechanism, the American Petroleum Institute code (published in 2007) underestimated the cyclic bending moment and the lateral pile displacement by 10% and 69%, respectively. Application of jet grouting around the semi-rigid pile at shallow depth significantly altered the soil flow mechanism (i.e., it was a solely wedge-type mechanism around the grouted zone).

Effects of Pile Installation Simulation on Behavior of Pile Groups in Centrifuge Model Tests

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Centrifuge Model Tests On Vertical Bearing Capacity Of Single Pile In Silty Clay

Centrifuge Testing and Numerical Modeling of Single Pile and Long-Pile Groups Adjacent to Surcharge Loads in Silt Soil

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

Displacement and Force Analyses of Piles in the Pile-Caisson Composite Structure under Eccentric Inclined Loading Considering Different Stratum Features

Centrifuge Study on Behavior of Rigid Pile Composite Foundation under Embankment in Soft Soil

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling

In-flight Simulation of Pile Installation in Slopes in Centrifuge Model Tests

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Effects of deep excavation on uplift capacity of piles by centrifuge tests

Centrifuge Shaking Table Tests on 4 × 4 Pile Groups in Liquefiable Ground