Abstract:In spine biomechanics, follower loads are used to mimic the in vivo muscle forces acting on a human spine. However, the effects of the follower load on the continuous biomechanical responses of the subaxial cervical spines (C2-T1) have not been systematically clarified. This study aims at investigating the follower load effects on the continuous biomechanical responses of C2-T1. A nonlinear finite element model is reconstructed and validated for C2-T1. Six levels follower loads are considered along the follower load path that is optimized through a novel range of motion-based method. A moment up to 2 Nm is subsequently superimposed to produce motions in three anatomical planes. The continuous biomechanical responses, including the range of motion, facet joint force, intradiscal pressure and flexibility are evaluated for each motion segment. In the sagittal plane, the change of the overall range of motion arising from the follower loads is less than 6%. In the other two anatomical planes, both the magnitude and shape of the rotation-moment curves change with follower loads. At the neutral position, over 50% decrease in flexibility occurs as the follower load increases from zero to 250 N. In all three anatomical planes, over 50% and 30% decreases in flexibility occur in the first 0.5 Nm for small (≤100 N) and large (≥150 N) follower loads, respectively. Moreover, follower loads tend to increase both the facet joint forces and the intradiscal pressures. The shape of the intradiscal pressure-moment curves changes from nonlinear to roughly linear with increased follower load, especially in the coronal and transverse planes. The results obtained in this work provide a comprehensive understanding on the effects of follower load on the continuous biomechanical responses of the C2-T1.

Influence of Fulcrum and Load Positions on Springboard Mechanics

An Examination of the Springboard Diving Run-up Approach

Development of a Novel Elastic Load-Carrying Device: Design, Modeling and Analysis

Nonlinear Spring Model for Dynamic Uplift Behaviour of Suction Caisson under Impact Loading

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Springing Analysis of Elastic Vessels in Head and Oblique Seas Including Nonlinear Effects Due to Second Order Diffraction Pressures

The analysis on jumping and taking off process in springboard diving by mechanics

Multi-springs Model for Suction Caisson under Monotonic Lateral Loading

Enhanced Multi-Springs Model for Estimating Suction Caisson Responses under Cyclic Lateral Loading

The dynamic behaviour of flexible oscillators rocking and sliding on concentrated springs

A Study on the Influence of Different Constraint Modes and Number of Disc Springs on the Dynamics of Disc Spring System

Studies on Results of Biofeedback in Springboard Diving Training

Complex Dynamical Behavior of Rigid-flexible Coupling Spring Pendulum

Dynamics of the long jump

Nonlinear Dynamics Research of Ground Undulatory Fin Robot with Flexible Deformation and Frictional Contact

Effect of Torsional Spring and Shape on the Performance of Bioinspired Caudal Fin

A finite element study on the effects of follower load on the continuous biomechanical responses of subaxial cervical spine

Effect of Dynamic Loads on the Interface Pressure at the Residual Limb of a Trans-Tibial Amputee

Optimization design of elastic bearing mechanism with cross leaf spring

A Full Range Experimental Study of Amplitude- and Frequency-Dependent Characteristics of Rubber Springs

The Effect of Coulomb Friction in Foil Structure on the Static and Dynamic Performance of Bump Foil Journal Bearings