Abstract:Researches of flow and dispersion in urban area are important to meet the practical demands of studies of vehicular exhaust pollution and accidental leakage. Numerical simulations with field observations and physical simulations (e.g., wind tunnel simulation) are often used to address atmospheric flow and dispersion problems in cities. In general, numerical simulations can provide specific detailed informations of flow, turbulence and dispersion. To deal with small-scaled flow and dispersion, computational fluid dynamics (CFD) models are widely applied and are capable of reproducing small-scaled characteristics of flow and dispersion. A CFD model-FLUENT was adopted to simulate the disturbance of a single building on atmospheric flow under the neutral stability condition. Wind tunnel data published by Hamburg University was collected to validate the modeled results and assess the choices of parameters and parameterization schemes. This technique was applied to address atmospheric dispersion problems in quasi-urban building arrays. Concentration data of MUST and a tracer experiment were used to evaluate the dispersion modeling. The results indicated that FLUENT well performed in mean flow simulation under construction disturbance condition. Simulated results for FAC2 of horizontal and vertical modeling wind speed were 77.9% and 61.0% respectively. However, thre was a relatively larger discrepancy between the modeling and measured turbulence characteristics, when the FAC2 of modeling turbulent kinetic energy was 54.6%. The turbulent closure scheme options (i.e., standard K-ε scheme, Re-normalization Group K-ε scheme and Reynolds Stress Model scheme) had trivial effects on simulated results. The dispersion simulation case within quasi-urban buildings was satisfactory. The result of the dispersion case correctly reproduced the irregular plume shifting caused by building disturbance compared to the average wind direction. The modeling concentrations were generally in accordance with measured results, and the relative tolerance of the modeling maximum concentration in lateral profile at 32 and 63 m downwind were 72.5% and 36.9% respectively. Relative to the Gaussian plume model-ISC3, FLUENT can provide more practical concentration distribution under complex conditions. FLUENT simulation also indicated that the maximum lateral concentration decreased along the downwind direction in "step change" pattern between the adjacent street canyons near the release source. The maximum lateral pollutant concentrations in the same street canyon as the source were several times or even one order of magnitude higher than that in the next canyon. FLUENT results can reproduce the phenomena of dispersion towards upwind area and also of accumulation and detouring flow around the constructions. Further researches are required to analyze the phenomena.

CFD Simulation on LNG Dispersion

CFD simulation of effects of the configuration of gas distributors on gas–liquid flow and mixing in a bubble column

CFD Simulation for Up Flow Jet-Loop Reactors by Use of Bi-Dispersed Bubble Model

Comparisons for LNG Dispersion Models

Application of CFD Simulation for Optimisation of the Multi-Pipe Gas Distributors in a Large-Scale Shallow Bubble Column

Simulation and Verification of CFD on the Dispersion of Heavy Gas Leakage

CFD Simulation of Gas-Liquid Flow in Bubble Column

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

CFD Simulation of Flow Field,temperature Field and SO2 Absorption in Flue Gas Quench Tower

Computational fluid dynamics study on liquefied natural gas dispersion with phase change of water

Numerical study on plume characteristics of liquefied natural gas spills

Simulation Study on Instantaneous Release of LNG

Research on density measurement of liquefied natural gas storage tank based on computational fluid dynamics

Numerical Study Of Leaked Natural Gas Dispersion Within An Urban Street Canyon Considering The Distribution Of Ground Surface Flux

CFD Simulation on Gas Explosion Field in Linked Vessels

The design of heterogeneous simulation reactor based on Fluent

CFD Simulations of Flow and Dispersion under Construction Disturbance Conditions

LNG pool fire simulation for domino effect analysis

A Numerical Simulation of Lng Low Temperature Pipe Pre-Cooling Process

CFD simulation of gas holdup and gas-liquid flow in bubble columns

Process simulation of LNG receiving terminal