Abstract:The current rapid development of weak electrical installations has made the monitoring of weak signals increasingly important. For highly sophisticated instruments, the slightest signal deviation will cause terrible and irreparable damage. At present, commercially available multimeters generally have low accuracy, which does not meet the error range required for weak electrical signal monitoring, because it cannot be monitored in real-time, and requires manual handheld data collection. To address the above demands, this study designs and builds a voltage and current signal collector based on the STM32F103 microcontroller. In this case, the DC voltage is designed in the range of −5 V to 5 V, and for the current is from 4 to 20 mA, and the AC voltage from 0 to 5 V can be measured. The measurement results will be displayed on the LCD screen. The collector uses RS485 as the physical transmission interface and the communication protocol uses the Modbus-RTU protocol, which can work properly in the range of 10–24 V DC supply. The analysis of the corresponding requirements is followed by the circuit design to complete the transmission and display of the collected data. The DC voltage measurement part contains the process of boosting and dividing the circuit and then reading it, the current measurement is completed by an isotropic proportional amplifier circuit, and the AC voltage RMS measurement uses the AD637 true RMS conversion chip to realize the circuit, the design contains the software part, the hardware part, and the communication part design. The final device has been tested to meet the national standard of maximum permissible error range within ±0.1 and is suitable for the complex environment envisaged.

MEASUREMENT OF WEAK DC SIGNAL IN ON-LINE MONITORING SYSTEM OF XLPE POWER CABLES

Design of Measurement System for Electrical Tree in XLPE Cable Insulation at High Temperature

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

The Development of Mobile On-line Partial Discharge Monitoring System of XLPE Cable

On-line monitoring method for long distance power cable insulation

Online Monitoring of Power Cables Tangent Delta Based on Low-Frequency Signal Injection Method

An Online Measuring Method for Tangent Delta of Power Cables Based on an Injected Very-Low-Frequency Signal

Weak Current Signal Detection Device Based on Embedded System

Research of Metering Scheme Key Techniques for Medium and Low Voltage DC Distribution Network

Weak Current Detection Based On The Faims System

An Electrical Parameter Measurement System Based on DSP and LabVIEW

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

The Design of Calibration System Based on Cable Accessories

Design And Implementation Of Power Electronic Wireless Monitoring System Based On Zigbee Technology

Design Method of Multisine Signal for Broadband Impedance Measurement

The Application of Optical Sensing Technique in Fault Detection System for XLPE Underground Power Cables

Miniature Optical Signal Transmission System for PDN Noise Measurement

DEVELOPMENT OF ON-LINE MONITORING SYSTEM FOR PARTIAL DISCHARGE WITHIN POWER TRANSFORMER

Online Monitoring of Cable Insulation Degradation for Inverter-Fed Machine System Using PWM Switching Oscillations

Online Monitoring for Underground Power Cable Insulation Based on Common-Mode Signal Injection