Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Initial discussion on the bond problems of steel and concrete in Concrete Filled Steel Tubes(CFST)

Flexural strength analysis of non-post-tensioned and post-tensioned concrete-filled circular steel tubes

Experimental Investigation on Influence of Embedment Length, Bar Diameter and Concrete Cover on Bond Between Reinforced Bars and Steel Fiber Reinforced Concrete (SFRC)

Analysis on Bond Strength at the Interface of Centrifuge Concrete Filled Steel Tube

Bond Properties of Steel Angles in Concrete Filled Steel Tubes

Mechanism of Load Introduction and Transfer Within Steel-Encased CFST Members with Shear Connections

Experimental and theoretical research on bond behavior of concrete filled steel tube with inner steel tube

Experimental study and design of bond behavior in concrete-filled steel tubes (CFST)

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Experimental Investigation and Design of Concrete-Filled Steel Tubular CHS Connections

Experimental study on the steel–concrete bond behaviour of circular concrete-filled stainless steel tubes

Several Key Issues On Modern Concrete-Filled Steel Tubular Structures

Experimental study and numerical analysis of the interfacial bonding performance of T‐shaped concrete‐filled steel tubes

Primary discussion of construction mechanics of concrete -filled steel tubular structures

Seismic Performance of Concrete-Filled Steel Tubular (CFST) Structures

Studies on Constitutive Relationship for Concrete Filled Steel Tube

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Theoretical analysis on bond-slip constitutive relationship on tube and concrete interface in centrifuge concrete filled steel tubular structures

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

INVESTIGATION ON LIFE-CYCLE BASED THEORY OF CONCRETE-FILLED STEEL TUBULAR (CFST) STRUCTURES

Long-term Effects Including Shrinkage and Interfacial Creep on Bond Behavior of Concrete-Filled Steel Tubes (CFST): Experiment and Design