Abstract:Objective This study investigated the stress distribution in a femur after a cemented prosthetic replacement surgery in elderly patients with a partial marrow type I intertrochanteric fracture and compared the differences in stress distribution between a long- and short-stem prosthetic replacement. Methods A spiral computed tomography (CT) scan was used on the volunteer’s right femur to obtain image data, which were processed with the Mimics software and the modeling software to reconstruct a three-dimensional model of the femur. On this basis, the three-dimensional physical models for a partial marrow type intertrochanteric fracture, long- and short-stem femoral prostheses, and the mantle layer of cement were established. Finally, the three-dimensional finite element models of the long- and short-stem femoral prostheses as a treatment of an intertrochanteric fracture were established using the software for finite element analysis, and the biomechanical analysis was implemented for the models. Results The stress distribution in the femur after the cemented long- or short-stem prosthetic replacement did not change significantly; it still gradually increased from the proximal end to the distal end, reaching the peak value at the lower 1/3 of the medial and lateral junction, and then decreased to the end. Although a stress concentration zone formed in the medial and lateral end of the bone cement-prosthetic stem interface in the short-stem prosthesis, which had a lateral peak value of 15.3 MPa, it did not exceed the fatigue strength of the bone cement. Alternatively, a stress concentration zone formed in the distal medial and lateral end of the bone cement-prosthetic stem interface and the medial middle part of the shaft in the long-stem prosthesis, which showed a peak value that was also lower than the fatigue strength of the bone cement. No significant stress concentration zones were found in the femoral calcar reconstructed by bone cement. Conclusion The stress distribution in the femur did not change significantly after cemented long- and short-stem prosthetic replacements were used for elderly patients with a partial marrow type I intertrochanteric fracture. The probability of loosening of the cemented long-stem prosthesis was comparable to that of the short-stem prosthesis, but the latter may be more suitable for treating elderly patients with a partial marrow type I intertrochanteric fracture due to the shorter surgery time, minor trauma, and fewer complications.

The Biomechanical Study of Intertrochanic Fractures Treated with Cemented Femoral Stem

Theoretical analysis of changes in femoral stresses after total hip arthroplasty]

[Study on biomechanical stability in simulated femoral neck fracture fixation by two cannulated screws].

Biomechanical Study and Clinical Evaluation of Four Techniques in the Treatment of Intertrochanteric Fracture of the Femul

The Comparative Analysis with Finite Element for Cemented Long- and Short-Stem Prosthetic Replacement in Elderly Patients with a Partial Marrow Type I Intertrochanteric Fracture

Different implant fixation repairs femoral neck combined with ipsilateral subtrochanteric fractures：comparisons of biomechanical properties

Mechanical Test of Impaction Bone Grafting in Revision of Tibia (Initial Stability of Short and Long Stem)

Biomechanical Evaluation of a New Device for Internal Fixation of Femoral Neck Fractures

Biomechanical evaluation of two modified intramedullary fixation system for treating unstable femoral neck fractures: A finite element analysis

Biomechanical Study of Three Fixation Systems for Complex Unstable Femoral Intertrochanteric Fractures

The Stability of Fixation of Vancouver B2 Periprosthetic Femoral Fractures: Effect of Implantation Technique

The Cause and Treatment of Fracture of Cemented Femoral Stems after Hip Replacement

Biomechanical Experiment of Non-stemmed Anatomical Total Hip Prosthesis Arthroplasty in Vitro

Bond Strength Analysis of the Bone Cement-Stem Interface of Hip Arthroplasties

Biomechanical Evaluation of Three Implants for Treating Unstable Femoral Intertrochanteric Fractures: Finite Element Analysis in Axial, Bending and Torsion Loads

Biomechanical study of extramedullary and intramedullary fixation in the treatment of unstable intertrochanteric reversed-tilt fractures of the femur

Initial Damage Analysis in Bone Cement-Stem Debonding Procession of Cemented Hip Arthropsty

Biomechanical characteristic differences of two new types of intramedullary nail devices in the treatment of comminuted intertrochanteric fractures of femur: a comparative study based on finite element analysis

The primary stability of ultrashort residual proximal femur fixed with triangular fixation stem prosthesis: a comparative biomechanical study based on sawbones models

In Vitro Experimental Investigation of the Integrity of the Stem–Cement Interface

Computational analysis of the biomechanical stability of internal fixation of the lateral tibial plateau fracture: A mechanical stability study