Abstract:Numerical simulation was made of transient mass transfer to a surfactant contaminated buoyancy-driven drop controlled by appreciable resistance in both liquid phases. For this purpose, the momentum equations were formulated and solved in a boundary-fitted orthogonal coordinate system. On the basis of resolved hydrodynamics of the contaminated drop, the transient mass transfer was formulated and solved in the same coordinate system. In order to check the applicability of the numerical scheme, single drop extraction experiments were conducted in a totally closed droplet file column with the terminal effect efficiently eliminated. The MIBK–acetic acid–water system was used with small quantities of SDS (sodium dodecyl sulphate), Triton X-100, or Tween 80 introduced into the continuous phase. For these experimental cases, the flow field and the drag coefficient of a contaminated drop were simulated first. The numerical prediction of the drag coefficient is found in good agreement with the corresponding experimental data. It illustrates that the behavior of a drop approaches that of a rigid sphere and that about 100 times higher bulk concentration of SDS than that of Triton X-100 is required for the same extent contamination of a MIBK drop of the same size. Then the information of the flow field of a contaminated MIBK drop was used in simulating the transient mass transfer of solute into the drop. The resulted extraction fraction and overall mass transfer coefficient are in reasonable coincidence with the experimental data. Both numerical results and experimental data show that overall mass transfer coefficient of a heavily contaminated drop is only about one third of that in the pure system. This can be explained well by the distribution of the local Sherwood number, which drops down abruptly along the rear stagnant surface. Also the interfacial resistance of adsorbed surfactant was incorporated in the mass transfer model and then estimated by the least square fitting the simulation with data. The numerical results also show that Tween 80 presents obvious interfacial resistance on the acetic acid diffusing across the interface, whereas SDS and Triton X-100 show no interfacial resistance. It is suggested that the numerical simulation can be resorted in some solvent extraction systems containing surfactants to conduct numerical experiments and parametric study.

Study on liquid-liquid mass transfer of butanone in an emulsion liquid membrane

Liquid-liquid Two-Phase Flow and Mass Transfer in T-shaped Micro-Channel Network

Mass Transfer Characterization for Hydrocarbon Liquid–particle Collision Based on Sensitive Tracing of Fluorescent Probe

Investigation on Abatement of Exhaust Gas Loaded with VOCs by Emulsion Liquid Membrane

Study on phase behavior of [C16mim] [br]/CAHS/n-butanol/n-hexane/water microemulsions: synergistic effect of ionic liquid-zwitterionic surfactants

Mass Transfer and Reaction Kinetics of Soybean Oil Epoxidation in a Formic Acid‐autocatalyzed Reaction System

Study on the Interfacial Characteristic of Sulfolane-Aromatic Extraction System

A fundamental study on demulsification process by microfiltration membrane

An Experimental Study of Liquid-Liquid Microflow Pattern Maps Accompanied with Mass Transfer

The Dynamic Mass Transfer of Surfactants Upon Droplet Formation in Coaxial Microfluidic Devices

A Basic Study on Micropore Membrane Emulsification

Effects of nanoparticles with different wetting abilities on the gas–liquid mass transfer

Mass-Transfer-Controlled Dynamic Interfacial Tension in Microfluidic Emulsification Processes.

MASS TRANSFER KINETICS OF PERVAPORATION BY USING COMPOSITE SILICONE RUBBER MEMBRANE ( Ⅰ ) CONVECTIVE TRANSPORT ON MEMBRANE SURFACE

Effect of Swelling on Mass Transfer Performance in Membrane Extraction

Effect of Addition of Cosurfactant on the Phase Behaviour of Oil-in-water Aminosilicone Oil Microemulsion

Studies on interfacial tensions of betaine and anionic-nonionic surfactant mixed solutions

Effects of surface-active agents on mass transfer of a solute into single buoyancy driven drops in solvent extraction systems

Mass transfer model for liquid liquid micromixing systems

Solvent effect on ζ potential at an aqueous/oil interface in surfactant-free emulsion

Effect of Temperature on Surfactant Adsorption at the Liquid-Liquid Interface: Insights from Molecular Dynamics Simulations