Abstract:Numerical simulation was made of transient mass transfer to a surfactant contaminated buoyancy-driven drop controlled by appreciable resistance in both liquid phases. For this purpose, the momentum equations were formulated and solved in a boundary-fitted orthogonal coordinate system. On the basis of resolved hydrodynamics of the contaminated drop, the transient mass transfer was formulated and solved in the same coordinate system. In order to check the applicability of the numerical scheme, single drop extraction experiments were conducted in a totally closed droplet file column with the terminal effect efficiently eliminated. The MIBK–acetic acid–water system was used with small quantities of SDS (sodium dodecyl sulphate), Triton X-100, or Tween 80 introduced into the continuous phase. For these experimental cases, the flow field and the drag coefficient of a contaminated drop were simulated first. The numerical prediction of the drag coefficient is found in good agreement with the corresponding experimental data. It illustrates that the behavior of a drop approaches that of a rigid sphere and that about 100 times higher bulk concentration of SDS than that of Triton X-100 is required for the same extent contamination of a MIBK drop of the same size. Then the information of the flow field of a contaminated MIBK drop was used in simulating the transient mass transfer of solute into the drop. The resulted extraction fraction and overall mass transfer coefficient are in reasonable coincidence with the experimental data. Both numerical results and experimental data show that overall mass transfer coefficient of a heavily contaminated drop is only about one third of that in the pure system. This can be explained well by the distribution of the local Sherwood number, which drops down abruptly along the rear stagnant surface. Also the interfacial resistance of adsorbed surfactant was incorporated in the mass transfer model and then estimated by the least square fitting the simulation with data. The numerical results also show that Tween 80 presents obvious interfacial resistance on the acetic acid diffusing across the interface, whereas SDS and Triton X-100 show no interfacial resistance. It is suggested that the numerical simulation can be resorted in some solvent extraction systems containing surfactants to conduct numerical experiments and parametric study.

Study on the Interfacial Characteristic of Sulfolane-Aromatic Extraction System

Mass Transfer Characterization for Hydrocarbon Liquid–particle Collision Based on Sensitive Tracing of Fluorescent Probe

Exploring the Essence of Three-Phase Packed Distillation: Substantial Mass Transfer Computation

Surface/Interfacial Properties and Structures of Ionic Liquids

Effects of surface-active agents on mass transfer of a solute into single buoyancy driven drops in solvent extraction systems

Effect of Swelling on Mass Transfer Performance in Membrane Extraction

Prediction, Application, and Mechanism Exploration of Liquid–Liquid Equilibrium Data in the Extraction of Aromatics Using Sulfolane

Interfacial assignment of branched-alkyl benzene sulfonates: A molecular simulation

Extraction process design for the separation of aromatic and aliphatic hydrocarbons using organic solvent, ionic liquid or their mixture: a comparative study

Interfacial Effects on Nucleate Boiling Heat Transfer of Binary Mixtures

Study on liquid-liquid mass transfer of butanone in an emulsion liquid membrane

Molecular dynamics simulation study on interfacial behaviors of betaines and extended surfactants

Separation of the Azeotropic Mixture Methanol and Toluene Using Extractive Distillation: Entrainer Determination, Vapor–Liquid Equilibrium Measurement, and Modeling

Numerical study of the Marangoni effect induced by soluble surfactants and solute based on rising droplets

Separation mechanism and thermodynamic phase behavior of n-propanol/p-xylene azeotrope from petrochemical wastewater by green solvents

Study on Two-Phase Aqueous Extraction System

Phase behaviour and internal mechanism of action of two solvents for the separation of butanol isomers from industrial wastewater

The extraction of aromatics using n-methylpyrrolidone: Liquid-liquid equilibrium determination and mechanism exploration

Effect of molecular structure on synergism in mixed zwitterionic/anionic surfactant system: An experimental and simulation study

Modeling investigation of mass transfer of gas-liquid-liquid dispersion systems

Experiment and simulation of the interface characteristics during the two-phase invasion between silicone oil and water