Abstract:Hardness, activation volume and strain-rate sensitivity of Cu/Cr (face-centered cubic (fcc)/body-centered cubic) and Cu/Zr (fcc/hexagonal close-packed) nanostructured multilayer films have been systematically measured as a function of modulation period (L) and modulation ratio (η), respectively. Significant size effects were found for all the three plastic deformation characteristics, i.e. enhanced hardness and activation volume but reduced strain-rate sensitivity with decreasing the dimension length L. Microstructure evolution was statistically examined to rationalize these size dependences. It was crucially observed that abundant nanotwins existed in the Cu grains, though nanotwin formation was depressed with smaller L. This inverse size-dependent nanotwin formation is responsible for the reduction in strain-rate sensitivity, because the negative effect induced by the decreased nanotwins predominates over the positive effect coming from the raised interfaces/boundaries. A mechanistic model is modified to account for the interface effect as well as the nanotwin effect, which yields calculations of strain-rate sensitivity in broad agreement with the experimental results when L is larger than about 20nm. Below this critical length size, there are discrepancies between the calculations and the experimental results, due to the change in deformation mechanism from dislocation nucleation/slip in confined layers to dislocation crossing interfaces. A confined layer slip model is also modified by considering the nanotwin strengthening to quantitatively describe the L-dependent hardness. In addition, the effects of constituent phases and their relative content on the activation volume and strain-rate sensitivity of NMFs are discussed with regard to variation in η.

Strain rate sensitivity of Cu/Ta multilayered films: Comparison between grain boundary and heterophase interface

Strain rate sensitivity of unequal grained nano-multilayers

Size-dependent Strain Rate Sensitivity and Interface Structure Influenced Deformation Mechanisms in Ti/Ta and Ti/Zr Multilayers

Strain rate sensitivity of nanolayered Cu/X (X=Cr, Zr) micropillars: Effects of heterophase interface/twin boundary

Size-Dependent Deformation Mechanisms and Strain-Rate Sensitivity in Nanostructured Cu/X (X = Cr, Zr) Multilayer Films

The Effect of Coherent Interface on Strain-Rate Sensitivity of Highly Textured Cu/Ni and Cu/V Multilayers

Influence of strain rate on the compressive behavior of heterogeneous Cu/Ta multilayer: A molecular dynamics simulation study

Deformation Evolution of Cu/Ta Nanoscale Multilayer During Nanoindentation by a Molecular Dynamics Study

Deformation Kinetics In Cu/Ta Nanoscale Multi Layers

Thickness-Dependent Strain Rate Sensitivity of Nanolayers Via the Nanoindentation Technique

Effect of Interface Type on Deformation Mechanisms of Γ-Tial Alloy under Different Temperatures and Strain Rates by Molecular Dynamics Simulation

Unusual Strain Rate Sensitivity of Nanoscale Amorphous Cuzr/Crystalline Cu Multilayers

Strain Rate Effects on the Mechanical Response in Multi- and Single-Crystalline Cu Micropillars: Grain Boundary Effects

Strain Rate Sensitivity and Related Plastic Deformation Mechanism Transition in Nanoscale Ag/W Multilayers

Influence of grain boundary and twin boundary on the stretching deformation behaviors of Cu/Ta interface material

Molecular Dynamics Simulation of Effects of Interface Imperfections and Modulation Periods on Cu/Ta Multilayers

Comparisons Between Homogeneous Boundaries and Heterophase Interfaces in Plastic Deformation: Nanostructured Cu Micropillars Vs. Nanolayered Cu-based Micropillars

Grain Size Dependent Strain Rate Sensitivity in Nanocrystalline Body-Centered Cubic Metal Thin Films

Strain Rate and Anisotropic Effects on Incipient Plastic Deformation of Zn–Cu–Ti Alloy Sheets

Size- and constituent-dependent deformation mechanisms and strain rate sensitivity in nanolaminated crystalline Cu/amorphous Cu–Zr films

Effects of Cu Layers on the Deformation Behavior of CuTa/Cu Multilayer Thin Films