Abstract:The conventional method (CM) for shear lag analysis of thin-walled box girders supposes that the neutral axis coincides with the centroidal axis of the whole cross section, and thus neglects the axial equilibrium condition. An analytical method considering axial equilibrium and shear deformation, which is referred to as PM, is proposed for overcoming the defect of the conventional method. The longitudinal displacement of the web is introduced to satisfy the axial equilibrium condition and locate the neutral axis automatically. The shear deformation is considered according to the Timoshenko beam theory. Three independent shear lag functions are adopted for describing different shear lag intensities of the top, bottom and cantilever slabs. The governing differential equations for the displacement variables are deduced by means of the virtual work theorem and solved with the relevant boundary conditions. The analytical solution is then derived for the distance from the neutral axis to the top fiber of the cross section. The accuracy of the proposed method is validated by comparisons with the available experimental data as well as the finite element analysis results. Moreover, the distances from the neutral axis to the top fiber, axial forces, and stress difference ratios are analyzed for typical thin-walled box girders to quantify the influence of the axial equilibrium condition. Finally, an extensive parametric study is conducted to examine the effects of various geometric parameters on the stress difference ratio under different load types. The results show that the proposed method can provide good predictions for both deflections and axial stresses, and neglecting axial equilibrium leads to considerable underestimations of axial stresses especially at the top flange-web junctions over the interior support of the continuous box girder.

Simplified Calculation Method for Torsion Parameters of Thin-walled Box Girder Section

TORSIONAL DEFORMATION CALCULATION OF LARGE SPAN THIN-WALLED STEEL BOX GIRDER WITH OPEN SECTION

An analytical method and its application for large-section PC box girder bridges

Structural spatial analysis method of prestressed concrete box girder with corrugated steel webs

Simplified theoretical solution and practical calculation method for welded hollow spherical joints of rectangular hollow section members

Improved method for shear lag analysis of thin-walled box girders considering axial equilibrium and shear deformation

A Controversy and Its Settlement in the Calculation of Buckling Moments of Thin-walled Beams with Monosymmetrical I-sections under Distributed Loads

A New Derivation of the Buckling Theory of Thin-Walled Beams

Analysis of Pure Torsion for Thin-Walled Composite Mono-Box Beams with Multi-Cells

Research on Calculation Method of the Transverse Internal Force of Trapezoid Multi-cellular Box Girder Bridge

An Exact Theory for Curved Beams with Any Thin-Walled Open Sections

CALCULATING METHOD OF TORSION-BENDING ANALYSIS OF SIMPLY SUPPORTED STRAIGHT CONCRETE BEAMS ON RAILWAY CURVE

Spatial Finite Element Analysis for Dynamic Response of Curved Thin-Walled Box Girder Bridges

Design of Thin-Walled Centrifugal Concrete-Filled Steel Tubes under Torsion

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Shear Lag Including Axial Balance of Box Beams by Finite Segment Model

Reinforcement design method of RC box girder subjected to combined torsion

Numerical Method for Biaxially Loaded Reinforced and Prestressed Concrete Slender Columns with Arbitrary Section

Research on Torsion Behavior and Design Approach of Rectangular Concrete-filled Steel Tubular Members

Improved Calculation Method for Shear Stress Nonuniformity Coefficient of Thin‐Walled Flat Box Sections

DIRECT STRENGTH METHOD OF WELDED BOX-SECTION FOR PREDICTING ULTIMATE LOAD-CARRYING CAPACITY