Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Load-transfer mechanism in angle-encased CFST members under axial tension

Mechanism of Load Introduction and Transfer Within Steel-Encased CFST Members with Shear Connections

Mechanism of Load Introduction and Transfer Within Steel-Encased Concrete-Filled Steel Tube Connections

Load Introduction and Transfer Mechanism of K-type CFST Circular Section Connections

Numerical Investigation on Compressive Performance of CFST Columns with Encased Built-Up Lattice-Angles

Axial Compressive Behavior of FRP-confined Square CFST Columns Reinforced with Internal Latticed Steel Angles for Marine Structures

Experimental Behaviour of Reinforced Concrete-Filled Steel Tubes under Eccentric Tension

Flexural Behavior of Circular Section Concrete-Filled Steel Tubes with Embedded Latticed Angles

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

Flexural Tests and Behavior of Multi-Celled Corrugated-Plate CFST Members

Analysis of CFRP-confined CFST Columns Reinforced with Steel Angles under Axial Compression

Trussed square concrete-filled steel tubular hybrid structures subjected to axial compression

Behavior of Concrete-Encased CFST Members under Axial Tension

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Compressive Behavior and Design Calculations of CFST Slender Columns with Latticed Annular Steel Part

New insights into the mechanism of load transfer in steel-encased CFST connections

Load-Transfer Mechanism and Bond-Stress Components in Steel and Steel Fiber–Reinforced Concrete Structure

Trussed concrete-filled steel tubular hybrid structures subjected to axial compression: Performance and design calculation

Axial compression behavior of square section concrete-filled steel tubes reinforced with internal latticed steel angles

Eccentric compression behavior of circular concrete‐filled steel tubes reinforced with internal latticed steel angles

Numerical Study of Concrete-Encased CFST under Preload Followed by Sustained Service Load