Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Experimental Behaviour of Reinforced Concrete-Filled Steel Tubes under Eccentric Tension

Experimental Investigation on Large-scale Slender FRP-Concrete-Steel Double-Skin Tubular Columns Subjected to Eccentric Compression

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

Performance of Concrete-Filled Steel Tubes Subjected to Eccentric Tension

Flexural strength analysis of non-post-tensioned and post-tensioned concrete-filled circular steel tubes

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Performance of Concrete-Filled Stainless Steel Tubes Subjected to Tension: Experimental Investigation

Experimental investigation of thin-walled centrifugal concrete-filled steel tubes under torsion

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Experimental and theoretical analysis for centrifuge concrete filled-steel tubular members subjected to bending-torsion

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Eccentric compression behavior of circular concrete‐filled steel tubes reinforced with internal latticed steel angles

Design of Thin-Walled Centrifugal Concrete-Filled Steel Tubes under Torsion

Tensile Behaviour of Concrete-Filled Double-Skin Steel Tubular Members

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Experimental Behaviour of Concrete-Filled Steel Tubular Members under Lateral Shear Loads

Flexural Behavior of Circular Section Concrete-Filled Steel Tubes with Embedded Latticed Angles

Behavior of Concrete-Encased CFST Members under Axial Tension

Experimental Investigation and Design of Concrete-Filled Steel Tubular CHS Connections