Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Performance of Concrete-Filled Steel Tubes Subjected to Eccentric Tension

Experimental Behaviour of Reinforced Concrete-Filled Steel Tubes under Eccentric Tension

Flexural strength analysis of non-post-tensioned and post-tensioned concrete-filled circular steel tubes

Seismic Behavior of Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

Performance of Concrete-Filled Stainless Steel Tubes Subjected to Tension: Experimental Investigation

Performance and calculations of concrete filled steel tubes (CFST) under axial tension

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Numerical Investigation on the Performance of Concrete-Filled Double-Skin Steel Tubular Members under Tension

Combined Axial and Flexural Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Tensile Behaviour of Concrete-Filled Double-Skin Steel Tubular Members

Behavior of Concrete-Encased CFST Members under Axial Tension

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Flexural Behavior of Circular Section Concrete-Filled Steel Tubes with Embedded Latticed Angles

Study on Mechanical Properties of Concrete-Filled Steel Tubular Members under Axial Tension

Circular Concrete-Filled Steel Tubes Subjected to Coupled Tension and Chloride Corrosion

Torsional Behaviour of Concrete-Filled Circular Steel Tubular Members under Coupled Compression and Torsion

Performance of Concrete-Filled Thin-Walled Steel Tubes under Pure Torsion

Flexural Performance of Concrete-Encased Concrete-Filled Steel Tubes