Abstract:Phased array ultrasonic testing (PAUT) based on full matrix capture (FMC) has recently been gaining popularity in the scientific and nondestructive testing communities. FMC is a versatile acquisition method that collects all the transmitter-receiver combinations from a given array. Furthermore, when postprocessing FMC data using the total focusing method (TFM), high-resolution images are achieved for defect characterization. Today, the combination of FMC and TFM is becoming more widely available in commercial ultrasonic phased array controllers. However, executing the FMC-TFM method is data-intensive, as the amount of data collected and processed is proportional to the square of the number of elements of the probe. This shortcoming may be overcome using a sparsely populated array in transmission followed by an efficient compression using compressive sensing (CS) approaches. The method can therefore lead to a massive reduction of data and hardware requirements and ultimately accelerate TFM imaging. In the present work, a CS methodology was applied to experimental data measured from samples containing artificial flaws. The results demonstrated that the proposed CS method allowed a reduction of up to 80% in the volume of data while achieving adequate FMC data recovery. Such results indicate the possibility of recovering experimental FMC signals using sampling rates under the Nyquist theorem limit. The TFM images obtained from the FMC, CS-FMC, and sparse CS approaches were compared in terms of contrast-to-noise ratio (CNR). It was seen that the CS-FMC combination produced images comparable to those acquitted using the FMC. Implementation of sparse arrays improved CS reconstruction times by up to 11 folds and reduced the firing events by approximately 90%. Moreover, image formation was accelerated by 6.6 times at the cost of only minor image quality degradation relative to the FMC.

Ultrasonic Phased Array Total Focusing Method Based on Sparse Deconvolution

Sparse Deconvolution Method for Ultrasound Images Based on Automatic Estimation of Reference Signals.

Enhancing Ultrasonic Time-of-flight Diffraction Measurement Through an Adaptive Deconvolution Method

3-D Ultrasonic Image Reconstruction in Frequency Domain Using a Virtual Transducer Model.

Adaptive Total Focusing Method for Ultrasonic Full-Matrix Imaging of Anisotropic CFRP Laminates

A Modified Wavenumber Algorithm of Multi-Layered Structures with Oblique Incidence Based on Full-Matrix Capture

Frequency Domain Synthetic Aperture Focusing Technique for Variable-Diameter Cylindrical Components.

An optimized total focusing method based on delay-multiply-and-sum for nondestructive testing

A Model-Based Regularized Inverse Method for Ultrasonic B-scan Image Reconstruction

Ultrasonic Array Imaging of Multilayer Structures Using Full Matrix Capture and Extended Phase Shift Migration

Frequency-domain Synthetic Aperture Focusing for Helical Ultrasonic Imaging

Efficiency Improvement of Total Focusing Imaging Based on Sparse Array Method

Ultrasonic Phased Array Total Focusing Method of Imaging with Rayleigh Waves Based on Principal Component Analysis

Total Focusing Method for Ultrasonic Non-Destructive Inspection of Homogenous Objects Based on Elliptical Arc Scan-Conversion

Optimal Design of Sparse Matrix Phased Array Using Simulated Annealing for Volumetric Ultrasonic Imaging with Total Focusing Method

Defect Detection Study on Total Focus Method of Sound Field Imaging Based on Parallel Processing

Advanced Orthogonal Frequency and Phase Modulated Waveform for Ultrasonic Phased Array TFM Detection in CFRP Composites

Quantitative Comparison of the Total Focusing Method, Reverse Time Migration, and Full Waveform Inversion for Ultrasonic Imaging

Real-Time Total Focusing Method Imaging for Ultrasonic Inspection of Three-Dimensional Multilayered Media

Optimization Method of DDF for Ultrasonic Phased Array

Compressive Sensing Strategy on Sparse Array to Accelerate Ultrasonic TFM Imaging