Compressed Dynamic Mode Decomposition for the Analysis of Centrifugal Compressor Volute

Yang Xiaojian,Zhu Xiaocheng,Hu Chenxing,Du Zhaohui

DOI: https://doi.org/10.1016/j.ijheatfluidflow.2018.09.013

IF: 2.643

2018-01-01

International Journal of Heat and Fluid Flow

Abstract:The compressed dynamic mode decomposition (compressed DMD) is used to analysis the unsteady characteristics of a centrifugal compressor. Firstly, to extract the unsteady flow structures of the volute under the mild surge condition, dynamic mode decomposition (DMD) method is applied to the flow field snapshots. The results indicate that the characteristic frequencies relating to the blade passing frequencies (BPFs) and corresponding modes are captured. Besides, the perturbation oscillating with the characteristic frequency (233.5 Hz), which is generated by the non-synchronic unsteady flow, is also obtained accurately. The non-synchronic unsteady flow is vividly shown by the reconstruction of the mild surge mode. Ten, the unsteady flow of the volute is also analyzed by the compressed DMD method, which is performed on the much compressed datasets and thus saves the calculation time. The dominant characteristic frequencies and corresponding modes can also be extracted accurately by the compressed DMD method when adopting an appropriate compression ratio. The compression ratio has an important influence on the results of the compressed DMD method. Considering the dominant frequencies and the energy ratio spectrum, a conservative recommendation of the compression ratio is 1% in this case. The energy ratio scaling method performs better than the amplitude scaling method.