Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Theory and analysis method based on vorticity dynamics for gas turbine compressor

Vorticity Dynamics in Axial Compressor Flow Diagnosis and Design—Part II: Methodology and Application of Boundary Vorticity Flux

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

Over-all performance analysis of a dual-entry turbocharger compressor with variable geometry orifice

Analytic Method for Computing Axial-flow Compressor and Turbine Characteristics

Analysis and Improvement of a Two-Stage Centrifugal Compressor Used in an MW-Level Gas Turbine

Performance Analysis of a Centrifugal Compressor Based on Circumferential Flow Distortion Induced by Volute

A Boundary Vorticity Diagnosis of the Flows in a Model Pump-Turbine in Turbine Mode

Enlarging the Operation Range of A Centrifugal Compressor by Cutting Vanes Based on Cfd

Bleed air CFD modelling in aerodynamic simulation of A heavy duty gas turbine compressor

Influence of the Volute on the Flow in a Centrifugal Compressor of a High-Pressure Ratio Turbocharger

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Numerical study of the coherent characteristics of the blade tip of a micro centrifugal compressor and its application in a new unsteady casing-treatment experiment

Vortex Generator Evaluation Models and Flow Mechanisms for Compressor Cascade

Performance Improvement of a High Loading Centrifugal Compressor with Vaned Diffuser by Hub Contour Optimization

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Analysis of the Performance of the Compressor

Influence of Volute Design on Flow Field Distortion and Flow Stability of Turbocharger Centrifugal Compressors

Effects of Nonaxisymmetric Volute on Rotating Stall in the Vaneless Diffuser of Centrifugal Compressors

Development and application of a throughflow method for high-loaded axial flow compressors