Abstract:Lean-burn natural-gas spark-ignition combustion inside a diesel geometry is characterized by two distinct and successive events: a rapid burning process inside the piston bowl, followed by a much slower burn inside the squish region. This paper used experimental data (including images of flame natural luminosity) to investigate the magnitude and phasing of these two combustion stages. The results showed a substantial impact on the parameters generally used to investigate the combustion phenomena in spark-ignition engines (e.g., the 10-to-90-percent energy release). A better solution to identify the start and end of the rapid- and the slow-burning stages in such an engine is to use the inflection points in the apparent rate of heat release. Moreover, as the higher turbulence in a diesel-like environment accelerates flame inception, the 5% or 10% energy release used traditionally to define the flame inception period should not be used for these engines because the enflamed zone already reached an appreciable size at the two corresponding crank angle degrees. Further, the 2nd inflection point in the apparent rate of heat release (i.e., the point where the slow-burning stage started to dominate the heat release) was much advanced compared to 90% energy release generally used to define the end of the rapid-burning stage in conventional stoichiometric spark-ignition engines. Furthermore, as the slow-burning stage was characterized by a lower flame propagation speed, a lower fuel fraction burning during this stage would increase the engine combustion efficiency. Furthermore, a more advanced phasing of the late-burning stage relative to the fast-burn stage would result in a more optimal combustion environment (i.e., higher in-cylinder pressure and temperature), which would further improve the engine efficiency and probably reduce carbon monoxide and unburned hydrocarbon emissions. As a result, this study suggests that the combustion strategy of such converted diesel engines should advance and optimize the mass of fuel that burns inside the squish region.

Closed-loop combustion phase control for multiple combustion modes by multiple injections in a compression ignition engine fueled by gasoline-diesel mixture

Analysis of Two-Stage Natural-Gas Lean Combustion Inside a Diesel Geometry

Controlling of Gasoline HCCI Combustion Phase and Transient Operation

Closed-Loop Diesel Combustion Control Leveraging Ignition Assist

Modeling and Control of Combustion Phasing in Dual-Fuel Compression Ignition Engines

Study of Multimode Combustion System with Gasoline Direct Injection

Cylinder-Specific Model-Based Control of Combustion Phasing for Multiple-Cylinder Diesel Engines Operating with High Dilution and Boost Levels

On improving the controllability of low-temperature combustion by building two-stage sequential high-temperature reactions in an ethanol/diesel dual-fuel engine using multiple injections

Controlling combustion with negative valve overlap in a gasoline–diesel dual-fuel compression ignition engine

Numerical simulation of mixture formation and combustion of gasoline engines with multi-stage Direct Injection Compression Ignition (DICI)

Experimental study of independent two-stage in-cylinder heat release using jet controlled compression ignition

Control of a spark ignition homogeneous charge compression ignition mode transition on a gasoline direct injection engine

Closed-loop control of low temperature combustion in diesel engines with cylinder pressure information

HCCI combustion control by injection strategy with negative valve overlap in a GDI engine

Control of Homogeneous Charge Compression Ignition Combustion in a Two-Cylinder Gasoline Direct Injection Engine with Negative Valve Overlap

Injection Strategy Optimization for a Multiple Premixed Compression Ignition Engine Based on Taguchi Method

Combustion Mode Switching Control in A Hcci Diesel Engine

Comparative Study of Low Octane Gasoline Multiple Premixed Compression Ignition and Conventional Diesel Combustion

Simulation and Experiments of Advanced Gasoline Engine Combustion Modes from Spark Ignition to Compression Ignition

Experimental and Computational Studies on Gasoline HCCI Combustion Control Using Injection Strategies

Development of a new control platform for compression ignition engines