Microstructure and Mechanical Properties of Mg 2 Si/AZ91 Composites In Situ Synthesized by Using Silica Fume as the Si Source

Wenlong Zhang,Xianfeng Li,Dongyan Ding,Ping Gao

DOI: https://doi.org/10.1007/s11665-018-3632-z

IF: 2.3

2018-01-01

Journal of Materials Engineering and Performance

Abstract:Microstructure and mechanical properties of in situ Mg 2 Si/AZ91 composites fabricated using silica fume as the Si source were investigated. The composites contained α-Mg, network Mg 17 Al 12 , lamellar Mg 17 Al 12 , coarse polygonal Mg 2 Si and needle-type Mg 2 Si. Mischmetal modification eliminated the coarse polygonal Mg 2 Si and resulted in a decreased amount of lamellar Mg 17 Al 12 and refined matrix grain size. Solution and aging treatment made the network Mg 17 Al 12 transform into lamellar Mg 17 Al 12 . As the volume fraction of Mg 2 Si increased, the matrix grain size decreased, the amount of Mg 17 Al 12 increased, and more Mg 17 Al 12 precipitated in grain interiors as a result of the increased Al/Mg ratio caused by increasing the amount of Mg 2 Si. The tensile strength and elastic modulus were much higher for the modified composites than for the unmodified one and increased by both increasing the volume fraction of Mg 2 Si and performing aging treatment. The composites failed in a quasi-cleavage fracture mode, and coarse polygonal Mg 2 Si phases were responsible for the lowest ductility of the unmodified composite. The highest UTS of 291.55 MPa obtained is much higher than those reported so far by using fly ash as the Si source, indicating that silica fume is more suitable as the Si source to synthesize Mg 2 Si/AZ91 composites.