Abstract:AbstractThis work investigates the temperature field during the automated layup of carbon fiber reinforced thermoplastic composites. The heat transfer boundary conditions of the layup process are determined by establishing a mathematical model of the temperature field. The basic properties of the material are determined using CF/PEEK as the research object. The heat transfer parameters in the temperature field are analyzed to determine the thermal convection region affected by hot air and the radiated heat of the infrared lamp. And a finite element model of the temperature field is established. The FEM temperature field model was created to investigate heat transfer throughout the layup process, as well as the impact of mold heating, layup preheating, and varied heating temperatures on different layups. The temperature change law of different layups under different heating and preheating temperatures of hot air is analyzed; the online temperature measurement device is built. The experiment of automated fiber placement is carried out to analyze the heating performance of the infrared lamp and hot air gun and to determine their relevant parameters. Using the results of experiments and simulations, it has been determined that different mold temperatures are required for different layups; preheating can effectively reduce the temperature gradient between layups; and at a layup speed of 5 mm/s, a preheating temperature of 200 °C and a hot air temperature above 400 °C can ensure that the critical temperature between the prepreg wire bundle and layups reaches the melting point and they can be laid up normally.

Parametric Study on Heat Transfer for Tow Placement Process of Thermoplastic Composite

Modeling and Analysis of Heat Transfer in Fiber Placement Process of Thermoplastic Composites

Thermal Management for Thermoset Automated Fiber Placement Based on Infrared Heater Structure Arrangement

Temperature Field in the Heat Transfer Process of PEEK Thermoplastic Composite Fiber Placement

Modeling for Heat Transfer of the Thermoplastic Composites <I>In Situ</I> Automated Fiber Placement Process

Optimization of Thermoplastic Composites Process Parameters Based on Robotic Fiber Placement

Multi-pass Layup Process for Thermoplastic Composites Using Robotic Fiber Placement

Thermal Analysis of Cylindrical Molds Using Thermoplastic Composite During Robotic Fiber Placement

Thermoplastic Composites Fiber Placement Process Research

Optimization of Process Parameters for Robotic Fibre Placement

Numerical investigation of the effect of thermal gradients on curing performance of autoclaved laminates

Simulation of Non-isothermal Crystallization Kinetics of Thermoplastics During Fiber Placement Process

The Influence of Preheating on Automated Fiber Placement Speed

A Heat-Balance Method for Autoclave Process of Composite Manufacturing

The Optimization of Thermo-Compression Process Parameters of Continuous Carbon Fiber Reinforced PEEK Composites

The effect of temperature field on the characteristics of carbon fiber reinforced thermoplastic composites in the laying and shaping process

Modeling and Optimization of Interlaminar Bond Strength for Composite Tape Winding Process

An Improved Analytical Solution For Process-Induced Residual Stresses And Deformations In Flat Composite Laminates Considering Thermo-Viscoelastic Effects

Study on Heat Transfer Process of Carbon Fiber Preform with Uniform Temperature Field

Influence Mechanism And Optimization Analysis Of Technological Parameters For The Composite Prepreg Tape Winding Process

Numerical simulation at the micro-scale for the heat transfer modelling in the thermoplastic composites laser-assisted AFP process