Abstract:In situ compressive behavior of carbon fibers reinforced PPS laminates. This study investigates the influence of a combined thermal heat flux (imposed by a cone calorimeter) and a compressive loading on the deformation and damage mechanisms within quasi‐isotropic carbon fibers reinforced thermoplastic (polyetherether ketone [PEEK] and polyphenylene sulfide [PPS]) and thermosetting (epoxy) laminates. First, thermogravimetric Analyses conducted under nitrogen provide valuable information on the thermal decomposition of these materials depending on the matrix nature (580–510°C and 350°C, respectively) which is a key factor to explain the mechanical behavior under fire conditions. Second, under the same testing conditions (creep loading under a 50 kW/m2 heat flux), the time to failure is about 17 times as high (C/PEEK), twice as high (C/PPS) with respect to C/epoxy laminates. At the ply scale, the exposure of thermoplastic matrices (PEEK and PPS) to a 50 kW/m2 heat flux causes softening and thermal decomposition, facilitating the micro‐buckling of fiber bundles in matrix‐rich areas. At the laminates scale, this mechanism ultimately leads to the formation and propagation of plastic kink bands in the transverse direction. In epoxy‐based laminates, the onset of matrix pyrolysis occurs at lower temperatures (350°C) during thermal aggression, and thermal decomposition has started in all the plies of the laminates. Combined with the low ductility of the epoxy matrix, the compressive response is elastic‐brittle and results from the buckling of 0° plies outside the thermally‐damaged area. Highlights Study on the compression of polymer composites exposed to a 50 kW/m2 heat flux. The influence of the matrix nature (thermoplastic vs thermoset) is discussed. Time to failure is about 17 times higher in C/PEEK compared to C/Epoxy. Plastic kink bands propagate in thermoplastic composites at T > Tg. C/Epoxy laminates undergo buckling outside the thermally damaged area.

Temperature Distribution of Thick Thermoset Composites

Temperature field of thick thermoset composites: Simulation and experimental

Temperature Field of Thick Thermoset Composite Laminates During Cure Process

Numerical investigation of the effect of thermal gradients on curing performance of autoclaved laminates

Comparison of the in situ compressive behavior of carbon fibers woven ply laminates exposed to one‐sided heat flux: Thermoplastic versus thermosetting composites

STUDY OF TEMPERATURE DISTRIBUTION OF THICK POLYMERIC MATRIX COMPOSITES Ⅰ:SIMULATION

Prediction of the Temperature of Large Framed Mold and Curing Deformation of Composite Components in the Autoclave Process

Thermal Management for Thermoset Automated Fiber Placement Based on Infrared Heater Structure Arrangement

Autoclave manufacturing of thick composites

A Heat-Balance Method for Autoclave Process of Composite Manufacturing

Study on temperature gradient of ultra-thick foam sandwich composite structure during curing

Numerical Prediction of Temperature Distribution in Thermoset Composites During Laser Curing Process

Three-dimensional Cure Simulation of Stiffened Thermosetting Composite Panels

Temperature distribution analysis of carbon fiber reinforced polymer composites during self-resistance electric heating process

Study of the curing process of carbon fiber reinforced resin matrix composites in autoclave processing

Temperature Field in the Heat Transfer Process of PEEK Thermoplastic Composite Fiber Placement

Design Optimization of Molds for Autoclave Process of Composite Manufacturing

Quantitative relations between curing processes and local properties within thick composites based on simulation and machine learning

Simulation and Modeling of Polymeric Composite Temperature Change During Manufactory Process

The effect of temperature field on the characteristics of carbon fiber reinforced thermoplastic composites in the laying and shaping process

STUDY ON PROCESS SUITABILITY OF MANUFACTURING THICK-COMPONENT USING 5428/T700 SYSTEM