Abstract:Large-diameter monopiles are the predominant foundation solution for supporting offshore wind turbines. They are conventionally designed using soil reaction curves developed for long slender piles used for supporting offshore oil and gas platforms (e.g., the API p-y model). However, due to the difference in the length/diameter ratio and the resulting soil mechanisms, the use of p-y curves alone can lead to significant under-prediction of the lateral stiffness and capacity of monopiles. To overcome the shortcoming, the authors have previously proposed a conceptual two-spring framework, i.e., the so-called 'p-y + M-R-theta(R)' model, to capture the monopile response in soft clay under lateral loading. The framework uses distributed p-y springs to consider the lateral soil resistance along the pile above the rotation point (RP) and a single moment-rotation (M-R-theta(R)) spring attached at the RP to capture the entire soil resistance below the RP, i.e., the distributed resistance along the pile, base shear and base moment at the pile tip. The proposed p-y and M-R-theta(R) springs were curve-fitted to the results of 3D numerical analyses. However, as the stress-strain response and the shear strength profile inevitably influence the p-y and M-R-theta(R) springs, the applicability of the empirical formulations to soil conditions other than those examined is uncertain. This study proposes an enhancement to the 'p-y + M-R-theta(R)' framework, in which the p-y and M-R-theta(R) springs are not tied to a specific soil and strength profile but fundamentally linked to the properties that can be measured directly in the site investigation and laboratory. This extension is achieved through analytical analyses and an extensive parametric numerical study. The predictive capabilities of the model are demonstrated by back-analyses of finite element analyses and centrifuge model tests. The proposed model provides practising engineers with a simple yet powerful approach to use site-specific soil reaction curves in the design of monopiles embedded in soft clay.

A New Model for Response of Laterally Loaded Piles in Soil-Rock Mixtures

An Improved Model for the Horizontal Dynamic Response of Piles in Saturated Soil

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Lateral dynamic response of a partially embedded pile subjected to combined loads in saturated soil

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

A Bounding-Surface-based Cyclic "P-Y Plus M-θ" Model for Unified Description of Laterally Loaded Piles with Different Failure Modes in Clay

Performance of laterally loaded H-piles in sand

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling

Site-specific soil reaction model for monopiles in soft clay based on laboratory element stress-strain curves

A Multi-Axial Bounding Surface P-Y Model with Application in Analyzing Pile Responses under Multi-Directional Lateral Cycling

A Unified Lateral Soil Reaction Model for Monopiles in Soft Clay Considering Various Length-to-diameter (L/D) Ratios

A new p-y model for soil-pile interaction analyses in cohesionless soils under monotonic loading

Bounding-surface-based p-y model for laterally loaded piles in undrained clay

Ultimate Soil Resistance of the Laterally Loaded Pile in Uniform Sand

Lateral Dynamic Responses of Coastal Group Piles Considering Pile‒water‒soil Interactions

A bounding-surface based cyclic ‘p-y+M-θ’ model for unified description of laterally loaded piles with different failure modes in clay

Nonlinear response of laterally cyclic loaded pile in cohesionless soil based on conical strain wedge model

Nonlinear response of laterally loaded rigid piles in sliding soil

Lateral Response Analysis of a Large‐Diameter Pile Under Combined Horizontal Dynamic and Axial Static Loads in Nonhomogeneous Soil