Abstract:Porous copper fiber sintered wicks (PCFSWs) with homogeneous and gradient porosity are fabricated using a low-temperature solid-phase sintering method. In this study, the capillary pumping amount of PCFSWs are measured and the influences of fiber morphology, working fluid, porosity and its distribution on the capillary pumping performance of PCFSWs are investigated. Centrifugal tests are also conducted to determine the liquid holding performance of PCFSWs. The capillary pumping characteristic curves and maximum capillary pumping amount are discussed based on Darcy's law, and the calculated results agree well with the experimental results of maximum capillary pumping amount. With deionized water as the working fluid, the rough PCFSWs exhibit higher maximum capillary pumping amount than smooth PCFSWs. The capillary pumping amount of PCFSWs with homogeneous porosity first increases and then decreases with increasing porosity, and the maximum capillary pumping amount is obtained for the PCFSW with 70% porosity. Furthermore, much larger capillary pumping amount of 90-70% gradient porosity PCFSWs is observed with the high-porosity end close to the liquid level. When ethanol is selected as the working fluid, the capillary pumping amount of PCFSWs with homogeneous porosity gradually decrease with increasing porosity, and the maximum capillary pumping amount is obtained for the PCFSW with 60% porosity. For the PCFSWs with 70-90% gradient porosity, much larger capillary pumping amount is obtained with the low-porosity end close to the liquid level. In addition, the centrifugal tests show the rough PCFSWs with deionized water and low porosity possess a smaller centrifugal amount and show better liquid holding performance. (C) 2017 Elsevier Ltd. All rights reserved.

Effect of fabrication parameters on capillary pumping performance of multi-scale composite porous wicks for loop heat pipe

Investigation on fabrication and capillary performance of multi-scale composite porous wick made by alloying-dealloying method

Fabrication and capillary characterization of multi-scale micro-grooved wicks with sintered copper powder

Effect of Fabrication Parameters on Capillary Performance of Composite Wicks for Two-Phase Heat Transfer Devices

Enhanced capillary pumping performance of flexible heat pipe device with multi cross-section ultra-thin wick

Selective Laser Melting Manufacturing and Heat Transfer Performance Study of Porous Wick in Loop Heat Pipe

Evaluation of capillary performance of sintered porous wicks for loop heat pipe

Experimental study on capillary performance of sintered powder porous wick for loop heat pipes

Characterization of capillary performance of composite wicks for two-phase heat transfer devices

Heat Transfer in Loop Heat Pipe’s Wick: Effect of Porous Structure Parameters

Experimental study on the characteristics of loop heat pipe with modified carbon fiber felt wick

Development of Sintered Ni-Cu Wicks for Loop Heat Pipes

Effect of Powder Size on Capillary and Two-Phase Heat Transfer Performance for Porous Interconnected Microchannel Nets As Enhanced Wick for Two-Phase Heat Transfer Devices

Capillary Pumping Performance of Porous Copper Fiber Sintered Wicks for Loop Heat Pipes

Experimental Investigation of Capillary Force in a Novel Sintered Copper Mesh Wick for Ultra-Thin Heat Pipes

Pore size optimization and fluid channel analysis of composite wick and anti-gravity study

Thermal performance of loop heat pipe with porous copper fiber sintered sheet as wick structure

Three-dimensional Pore-Scale Simulations of Dynamic Wicking Processes on Micro-Structured Wicks

Fabrication and Capillary Performance of Multi-Scale Microgroove Ceramic Wicks Via Nanosecond Laser Irradiation for Ultrathin Ceramic Heat Pipes

Development of biporous wicks for flat-plate loop heat pipe

Experimental and Theoretical Study on Performance of Bi-Porous Wick for Passive Phase-Change Devices