Abstract:High primary rock stress can limit the generation of rock cracks caused by blasting, and blasting usually shows different rock breaking states under different primary rock stress conditions. There are a large number of naturally formed joints in rock mass, due to the limitations of laboratory tests, a numerical model of jointed rock mass was established using LS-DYNA software to investigate the evolution of blasting damage under various in-situ stresses and open joints. In this simulation, using the Lagrange-Euler (ALE) procedure and the equation of state (JWL) that defines explosive materials, the study considered different joint thicknesses (2cm, 4cm, and 6cm), joint angles (0°, 30°, 60°, and 90°), and in-situ stress conditions (lateral stress coefficients of 0.5, 1, and 2, with vertical in-situ stresses of 10MPa and 20MPa), through stress analysis and damage area comparison, the relationship between damage crack propagation and horizontal and vertical stress difference is explored. The research aimed to understand the mechanisms underlying crack initiation and propagation. The results show that: (1) The presence of joints exerts a barrier effect on the expansion and penetration of cracks. When explosion stress waves reach the joint surface, their propagation is impeded, leading to the diffusion of wing cracks at the joint ends. When the lateral stress coefficient and joint angle are the same, an increase in initial in-situ stress results in a reduction in the area of the blasting damage zone. (2) Under the same initial in-situ stress conditions, the area of the blasting damage zone initially increases and then decreases with an increasing joint angle. However, it remains larger than that without a joint, and there exists an optimal angle that maximizes the damage area. In the simulated conditions, the area of damage cracks is greatest when the joint angle is 60° dip angle. (3) The presence of initial in-situ stress has a certain impact on the initiation and expansion of blasting cracks. The degree and nature of this influence are not solely related to the lateral stress coefficient but also depend on the joint's angle and thickness. When in-situ stress is present, the initial in-situ stress field's pressure is not conducive to the initiation and propagation of blasting cracks. However, the existence of a joint has a noticeable guiding and promoting effect on crack propagation, and the pattern of crack propagation is influenced by both joint and in-situ stress conditions.

Numerical simulations of rock blasting damage based on laboratory-scale experiments

Anisotropic Dynamic Damage and Fragmentation of Rock Materials under Explosive Loading

Numerical Simulation of Dynamic Damage and Stability of a Bedding Rock Slope under Blasting Load

Numerical simulation of rock blasting under different in-situ stresses and joint conditions

A modified JH2 model with improved strength model, damage evolution, and equation of state for rock under impact and blasting loads

Damage Evolution of Rocks Containing a Set of Cross-Joints Based on Acoustic Emission Characteristics

Finite element analyses of constitutive models performance in the simulation of blast-induced rock cracks

Rate-dependent constitutive modelling blasting crack initiation and propagation in rock masses

Numerical modelling of blast-induced crack propagation in pre-fractured rock

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Understanding the effect of differential stress and fracture geometry on blast-induced damage in crystalline rocks: a numerical approach

Numerical analysis on rock blasting damage in Xiluodu underground powerhouse using an improved constitutive model

Dynamic response and constitutive model of damaged sandstone after triaxial impact

Numerical investigation of blast-induced fractures in granite: insights from a hybrid LS-DYNA and UDEC grain-based discrete element method

Numerical Investigation of Abrasive Water Jet Rock Damage Characteristics That Considers the Shape, the Interaction and the Fragmentation of Abrasive Particles

Numerical simulation of the damage process of rock containing cracks by impacts of steel-particle water jet

Effect of confining pressure on damage accumulation of rock under repeated blast loading

Numerical simulation of column charge explosive in rock masses with particle flow code

Analysis of Damages in Layered Surrounding Rocks Induced by Blasting During Tunnel Construction

3D Damage and Failure Patterns in Rock due to Blasting at Different Open Joints Dig Angles

A modified Holmquist‒Johnson‒Cook (HJC) constitutive model and its application to numerical simulations of explosions and impacts in rock materials