Abstract:The gas entrainment (GE) due to a hollow vortex has been studied theoretically, experimentally and numerically to establish the design of a sodium-cooled fast reactor which can be operated stably without the core power disturbance caused by entrained bubbles. As a part of the GE study, the authors are developing a high-precision numerical simulation method to evaluate the GE phenomena accurately. The simulation method has been already applied for the simulations of some GE experiments and the simulation results show good agreement with the experimental data. The verification and validation (V&V), however, has not been conducted enough to show the uncertainty of the simulation method because the GE is a highly complicated phenomenon and there are few theoretical and/or experimental data which can be employed for the V&V study. In such a case, the method of manufactured solution (MS) is a promising method to evaluate the numerical error. Few MSs, however, are proposed for the flows with dynamic gas-liquid interface movement due to the difficulty in modeling mathematically the flow-interface interaction. In this paper, the authors develop a new MS which models the GE, i.e. the dynamic interfacial deformation due to a hollow vortex. The MS is considered on an axisymmetric system and radial, circumferential and axial velocities and pressure are formulated to satisfy the continuity equation and the boundary condition on an interface. The interfacial dent grows with time and a gas bubble is generated when the lower part of the interfacial dent is pinched off. The numerical simulation with the authors’ high-precision method shows reasonable agreement with the MS in terms of the interfacial dynamic behavior including the bubble pinch-off. In addition, it is confirmed that the simulation accuracy is enhanced by increasing the mesh resolution. Therefore, the developed MS is considered as a good problem for the verification of an interface-tracking method.

Surrogate Modeling for Liquid-Gas Interface Determination under Microgravity

Numerical Simulation of Sloshing in the Propellant Tank of Reusable Rocket Vehicle Using Meshfree Method

A Generalized Coupled Level Set/volume-of-fluid/ghost Fluid Method for Detailed Simulation of Gas-Liquid Flows.

Numerical Simulation of Gas-Assisted Injection Molding Using CLSVOF Method

Evaluation of different interface-capturing methods for cryogenic two-phase flows under microgravity

Appropriate Formulations for Velocity and Pressure Calculations at Gas-liquid Interface with Collocated Variable Arrangement

Multi-Scale Modeling of the Gas-Liquid Interface Based on Mathematical and Thermodynamic Approaches~!2009-11-08~!2010-03-22~!2010-05-17~!

Numerical Simulation on Interface Evolution and Pressurization Behaviors in Cryogenic Propellant Tank on Orbit

Numerical Simulation of Moving Interfaces in Gas-Assisted Injection Molding Process by Level Set Approach

3D Numerical Simulation of Gas-assisted Injection Molding

A Generalized Variational Level Set Method Without Frequent Reinitialization for Simulations of Gas-Liquid Flows.

Multi-Scale Gas-Liquid Interfacial Model

Study on Multi-scale Modeling of Gas-Liquid Interface and Microbubble Coalescence

Verification of interface-tracking method with manufactured solution

Numerical Simulation of Vapor Configuration and Bubbles Coalescence in Cryogenic Propellant Tank under Microgravity

Profiles of free Surfaces in Revolved Containers Under Microgravity

Simulating liquid–gas interfaces and moving contact lines with the immersed boundary method

A gas-surface interaction algorithm for discrete velocity methods in predicting rarefied and multi-scale flows: For Maxwell boundary model

Analysis and Modeling of No-Vent Filling Process for Liquid-Hydrogen Tank in Orbital Conditions

Three-dimensional numerical simulation of liquid sloshing in spacecraft containers in low-gravity environments

Numerical investigation of liquid oxygen filling process in liquid rocket engine by a multi-dimensional co-simulation method