Abstract:In the design study of large-sized sodium-cooled fast reactors in Japan (JSFR), the suppression of gas entrainment (GE) phenomena at a free surface in the reactor vessel is very important to establish an economically superior design. However, the GE phenomena are highly non-linear and too difficult to be evaluated theoretically. Therefore, we are developing high-precision CFD method for gas-liquid two-phase flows to evaluate the GE phenomena accurately. To reproduce the GE phenomena by CFDs, there are three key issues, i.e. geometry dependency, interfacial dynamics and locality. Former two issues are already addressed by employing unstructured mesh schemes and a high-precision simulation method for gas-liquid two-phase flow based on the PLIC (Piecewise Linear Interface Calculation) method, respectively. In fact, the simulation results of the GE phenomena in a simple GE experiment showed good agreements with experimental data. Recently, therefore, we focus on the locality of the GE phenomena. In our previous study (presented in ICONE17), the two-dimensional unstructured adaptive mesh technique for single-phase flows was developed to address the third issue. The isotropic cell refinement method was employed and the connection cell method was proposed to eliminate the edge incompatibility. The verification/validation results showed that the developed unstructured adaptive mesh technique succeeded in providing a high-precision solution, even though a poor-quality distorted mesh at the initial state was employed. In this study, the unstructured adaptive mesh technique is extended to the numerical simulations of gas-liquid two-phase flows. The redistribution methods of two-phase flow variables are newly developed to satisfy the conservations of the variables, i.e. the volumes of gas and liquid phases, the location of interfaces and the momentum of each phase. This improved unstructured adaptive mesh technique for gas-liquid two-phase flows is validated by solving the well-known slotted disk revolution and dam-break problems. As a result, the unstructured adaptive mesh technique succeeds in maintaining the slotted-disk shape after one revolution and shows more than first order accuracy (grid convergence) in the slotted-disk revolution problem. In addition, thanks to the momentum-conservative formulation, the dam-break phenomenon is well simulated by the unstructured adaptive mesh technique. Especially, wave-breaking phenomena are simulated by refined cells near the gasliquid interface. It should be noted that these simulation results are obtained by using relatively small number of cells because of the efficient mesh adaptation by the unstructured adaptive mesh technique.

Appropriate Formulations for Velocity and Pressure Calculations at Gas-liquid Interface with Collocated Variable Arrangement

Examination of Appropriate Formulations for Velocity and Pressure Calculation Methods at Interfacial Region on Collocated Physical Variables' Distribution

F211 Formulation of high-precision volume-of-fluid method establishing appropriate balance between pressure and surface tension and its application to gas entrainment phenomena in fast breeder reactors

Formulations and Validations of a High-Precision Volume-of-Fluid Algorithm on Nonorthogonal Meshes for Numerical Simulations of Gas Entrainment Phenomena

AN IMPROVED PRESSURE CALCULATION METHOD FOR SIMULATIONS OF GAS–LIQUID TWO-PHASE FLOWS ON UNSTRUCTURED MESHES

Formulation of High-Precision Volume-of-Fluid Method Establishing Appropriate Balance Between Pressure and Surface Tension and Its Application to Gas Entrainment Phenomena in Fast Breeder Reactors(Fast Reactor,<Special Issue>Power and Energy System Symposium)

- 1-development and validation of high-precision cfd method with volume-tracking algorithm for gas-liquid two-phase flow simulation on unstructured mesh i 1

A High‐precision Unstructured Adaptive Mesh Technique for Gas–liquid Two‐phase Flows

Unstructured Adaptive Mesh Technique for Gas-Liquid Two-Phase Flows

High-Precision Reconstruction Of Gas-Liquid Interface In Plic-Vof Framework On Unstructured Mesh

Real-Scale Numerical Simulation of Gas Entrainment Phenomena in Fast Reactor

Two-Phase Flow Simulation of Gas Entrainment Phenomena in Large-Scale Experimental Model of Sodium-Cooled Fast Reactor

A Generalized Coupled Level Set/volume-of-fluid/ghost Fluid Method for Detailed Simulation of Gas-Liquid Flows.

High-Precision Calculation of Interface Normal on Non-Orthogonal Mesh

Multi-Scale Modeling of the Gas-Liquid Interface Based on Mathematical and Thermodynamic Approaches~!2009-11-08~!2010-03-22~!2010-05-17~!

Trial 2D Simulation of Microbubble Interaction Based on Multi-Scale Multiphase Flow Equation(Fluids Engineering)

Multi-Scale Gas-Liquid Interfacial Model

Fundamental Numerical Simulation of Microbubble Interaction Using Multi-scale Multiphase Flow Equation

Verification of interface-tracking method with manufactured solution

Study on Multi-scale Modeling of Gas-Liquid Interface and Microbubble Coalescence

Numerical Simulation of Gas-Assisted Injection Molding Using CLSVOF Method