Abstract:Understanding the micromechanical mechanism of the rock creep process is of great importance for studying the macroscopic time-dependent behavior of rocks. In this study, the evolution characteristics of the microstructure (cracks and pores) of saturated sandstones under short term and creep uniaxial compression conditions were investigated with the nuclear magnetic resonance (NMR) technique. The samples were first loaded to different stress levels and creep stages and then completely unloaded for NMR testing. Based on the testing results, the macroscopic deformation behavior, moisture migration law, pore size distribution, porosity, and microstructure change of the each sample under the short-term loading or different stages of creep were quantitatively analyzed. After that, by introducing a nonlinear elasto-viscoplastic damage creep model (EVP) by Zhao et al. (18:04017129, 2018), the relationships between the macroscopic irreversible strains and microscopic porosity increments were established. Overall, it was observed that: (1) regardless of the stress level, the magnitudes of the axial and lateral critical strains of samples at the onset of the accelerating creep stage are both relatively constant, and the axial strain is almost comparable to that at the peak stress in the short-term test, while the lateral strain is larger than that of the short-term test. (2) During the mechanical tests, the moisture in the samples migrates from large pores into small pores, and after mechanical tests, the porosities of the samples increase, in which the small pores always account for a larger proportion. (3) Corresponding to the three creep stages, the porosity of the sample increases slightly after the transient stage, increases to a constant value that is largely independent of stress after the steady stage, and increases significantly after the creep failure. In particular, compared to the initial porosity of 6.7%, the average porosities of samples taken to the onset of the tertiary stage and creep failure is 7.49% and 8.71%, increasing by 16.7% and 29.8%, respectively. (4) The porosity growth of sandstone during the brittle creep is mainly driven by the microscopic subcritical crack growth along the grain boundaries.

Microcrack Evolution and Associated Deformation and Strength Properties of Sandstone Samples Subjected to Various Strain Rates

Creep Behavior of Sandstone Containing Impact-Induced Microcracks

Experimental investigation of the strain rate effect on crack initiation and crack damage thresholds of hard rock under quasi-static compression

Experimental Investigation on Fracture Behaviors and Acoustic Emission Characteristics of Sandstone under Different Strain Rates

Creep Behavior of Sandstone under the Coupling Action of Stress and Pore Water Pressure Using Three-Dimensional Digital Image Correlation

Study on the evolution law and quantitative characterization of micro-crack propagation in the compressive failure process of rocks

Experimental study on mechanical and acoustic emission characteristics of sedimentary sandstone under different loading rates

Time-dependent Cracking and Brittle Creep in Macrofractured Sandstone

An Experimental and Theoretical Investigation of Time-Dependent Cracking and Creep Behavior of Rocks under Triaxial Hydro-Mechanical Coupling

Cracking and Creep Behavior of Rocks Considering Propagation and Interaction of Adjacent Cracks under Hydro-Mechanical Coupling

Experimental study on the mechanical properties of red sandstone with fractures under different loading rates

Long-term creep and microscopic deformation mechanisms of sandstone using rock rheology creep equipment and scanning through high-resolution 3D XRM

EXPERIMENTAL STUDY ON MICRO-CRACKS EVOLUTION CHARACTERISTICS OF KEY ROCK UNIT OF SLOPE POTENTIAL SLIP SURFACE AND ANALYSIS ON SLOPE SLIP MECHANISM

Study on the mechanism of energy evolution and bearing degradation in pre-cracked sandstone under non uniform cyclic loading

Investigation of Microcrack Propagation and Energy Evolution in Brittle Rocks Based on the Voronoi Model

Experimental Study of Crack Evolution in Prefabricated Double-Fissure Red Sandstone Based on Acoustic Emission Location

Evaluating the Microstructure Evolution Behaviors of Saturated Sandstone Using NMR Testing under Uniaxial Short-Term and Creep Compression

Influence of the Crack Angle on the Deformation and Failure Characteristics of Sandstone under Stepped Cyclic Uniaxial Compression with a Constant Lower Limit

Investigation of Macroscopic Brittle Creep Failure Caused by Microcrack Growth Under Step Loading and Unloading in Rocks

Study on the Relationship Between Macroscopic Failure and Micro-Crack Evolution in Interbedded Sandstone

Strain rate effect on the fracture evolution of sandstones under quasi-static loading conditions: Insights from acoustic emission characteristics