Abstract:Due to its extensive application, the safety issue of lithium-ion battery has received increasing attention. For crashworthiness design of battery in electric vehicles, it is of great importance to investigate the response of the battery under mechanical loading and understand the mechanism of internal short circuit. Quasi-static and intermediate strain rate uniaxial tension tests were conducted on the electrodes and the separators. The high speed camera and DIC (digital image correlation) method were adopted to measure the strain while a self-design load cell was used to measure force in dynamic test. Either loading velocity or loading direction was varied in different tests. The upper limit of the test strain rate achieved 66 /sec. All the component materials showed strain rate dependency and separators demonstrated noticeable anisotropy. Quasi-static penetration tests were conducted on two different types of pouch cell using steel and plastic punch heads. For both Type A pouch cell and Type B pouch cell, during penetration process using plastic punch head, no significant voltage drop or temperature rise was observed. During penetration process using steel punch head, only Type A pouch cell produced short circuit. When the punch head was removed, the voltage of the cells could recover to certain level. From post mortem examination, it was found that for a single pouch cell, all the electrodes presented the same fracture mode that the stacked anode and cathode formed several fragments in the penetration path, while the separators in between only formed a central crack when the punch head went through. Since the separators had a larger elongation ratio than the electrodes, the extended separators around the rupture location could block the direct and constant contact between anode and cathode, electrodes and steel punch, which explained why no massive internal short circuit was initiated. The drop tower was used to conduct dynamic penetration test. The results indicated that under dynamic loading, internal short circuit was more likely to be triggered which can be explained by the strain rate effect of the separators. This study highlighted the importance of the separator to the safety performance of pouch cells.

State-of-Charge Dependence of Mechanical Response of Lithium-Ion Batteries: A Result of Internal Stress

Comparative Study of Mechanical-Electrical-thermal Responses of Pouch, Cylindrical, and Prismatic Lithium-Ion Cells under Mechanical Abuse

Stress and Strain Characterization for Evaluating Mechanical Safety of Lithium-Ion Pouch Batteries under Static and Dynamic Loadings

Insights into the Swelling Force in Commercial LiFePO4 Prismatic Cell

Mechanical-electrical-thermal Responses of Lithium-Ion Pouch Cells under Dynamic Loading: A Comparative Study Between Fresh Cells and Aged Ones

State of Charge Dependent Mechanical Integrity Behavior of 18650 Lithium-ion Batteries

Mechanical Modeling and Testing of Pouch Cells under Various Loading Conditions

Stress State Characterization of Li-Ion Batteries Based on a Membrane Sensor

Effect of external pressure and internal stress on battery performance and lifespan

Simplified layered model of pouch cell for varied load cases: An indentation and three-point bending study

Different mechanical-electrochemical coupled failure mechanism and safety evaluation of lithium-ion pouch cells under dynamic and quasi-static mechanical abuse

Fracture Mode Analysis of Lithium-Ion Battery under Mechanical Loading

Mechanical Deformation of Lithium-Ion Pouch Cells under In-Plane Loads-Part I: Experimental Investigation

Temperature Dependence in Responses of Lithium-Ion Pouch Cells Under Mechanical Abuse

Deformation and Failure of Lithium-Ion Batteries Treated As a Discrete Layered Structure

Mechanical characterization of lithium-ion batteries with different chemistries and formats

Investigation of the mechanical response and modeling of prismatic lithium-ion batteries upon abusive loading

Mechanical Damage in a Lithium-Ion Pouch Cell under Indentation Loads

Mechanical stresses in pouch cells: a reduced order model

Mechanical testing and macro-mechanical finite element simulation of the deformation, fracture, and short circuit initiation of cylindrical Lithium ion battery cells

Comprehensive investigation on the durability and safety performances of lithium-ion batteries under slight mechanical deformation