Abstract:The use of superhydrophobic surfaces in a broad range of applications is receiving a great deal of attention due to their numerous functionalities. However, fabricating these surfaces using low-cost raw materials through green and fluorine-free routes has been a bottleneck in their industrial deployment. This work presents a facile and environmentally friendly strategy to prepare mechanically robust superhydrophobic surfaces with engineered lotus leaf mimetic multiscale hierarchical structures via a hybrid route combining soft imprinting and spin-coating. Direct soft-imprinting lithography onto starch/polyhydroxyurethane/cellulose nanocrystal (SPC) films formed micro-scaled features resembling the pillar architecture of lotus leaf. Spin-coating was then used to assemble a thin layer of low-surface-energy poly(dimethylsiloxane) (PDMS) over these microstructures. Silica nanoparticles (SNPs) were grafted with vinyltriethoxysilane (VTES) to form functional silica nanoparticles (V-SNPs) and subsequently used for the fabrication of superhydrophobic coatings. A further modification of PDMS@SPC film with V-SNPs enabled the interlocking of V-SNPs microparticles within the cross-linked PDMS network. The simultaneous introduction of hierarchical microscale surface topography, the low surface tension of the PDMS layer, and the nanoscale roughness induced by V-SNPs contributed to the fabrication of a superhydrophobic interface with a water contact angle (WCA) of ∼150° and a sliding angle (SA) of <10°. The PDMS/V-SNP@SPC films showed an ∼52% reduction in water vapor transmission rate compared to that of uncoated films. These results indicated that the coating served as an excellent moisture barrier and imparted good hydrophobicity to the film substrate. The coated film surfaces were able to withstand extensive knife scratches, finger-rubbing, jet-water impact, a sandpaper-abrasion test for 20 cycles, and a tape-peeling test for ∼10 repetitions without losing superhydrophobicity, suggesting superior mechanical durability. Self-cleaning behavior was also demonstrated when the surfaces were cleared of artificial dust and various food liquids. The green and innovative approach presented in the current study can potentially serve as an attractive new tool for the development of robust superhydrophobic surfaces without adverse environmental consequences.

Strong and Super-Hydrophobic Hybrid Carbon Nanotube Films with Superior Loading Capacity

Carbon Nanotubes Noncovalently Functionalized by an Organic-Inorganic Hybrid: New Building Blocks for Constructing Superhydrophobic Conductive Coatings

Nonaligned carbon nanotubes partially embedded in polymer matrixes: a novel route to superhydrophobic conductive surfaces.

Percolation-dominated Superhydrophobicity and Conductivity for Nanocomposite Coatings from the Mixtures of a Commercial Aqueous Silica Sol and Functionalized Carbon Nanotubes

Super-hydrophobic and Self-cleaning PVDF Film Fabricated by Chemical Bath Deposition

Fabrication of Self-Cleaning Polyvinylidene Fluoride Film

Superhydrophobicity of polyvinylidene fluoride membrane fabricated by chemical vapor deposition from solution

Preparation and Fluid Drag Reduction Properties of Superhydrophobic Paper-Based Films Comprising Carbon Nanotubes and Fluoropolymers

Superhydrophobic Carbon Nanotube Forests

Chemically Robust Carbon Nanotube – PTFE Superhydrophobic Thin Films with Enhanced Ability of Wear Resistance

Robust and Eco-Friendly Superhydrophobic Starch Nanohybrid Materials with Engineered Lotus Leaf Mimetic Multiscale Hierarchical Structures

Facile Fabrication Of Robust Superhydrophobic Multilayered Film Based On Bioinspired Poly(Dopamine)-Modified Carbon Nanotubes

Composite Lubricating Films with Silane Coupling Agent-Modified Carbon Nanotubes on a Silicon Substrate with Enhanced Wear-Resistant Properties

Superhydrophobic Waxy-Dendron-Grafted Polymer Films Via Nanostructure Manipulation

Fabrication of robust conductive and superhydrophobic coating based on carbon nanotubes

Fabrication of superhydrophobic surfaces with non-aligned alkyl-modified multi-wall carbon nanotubes

Superhydrophobic surface of hybrid nanocomposites made of TiO 2 and multi-walled carbon nanotubes: Photothermal ice removal performance and wear resistance

Facile Fabrication of Superhydrophobic Nanocomposite Coatings Based on Water‐Based Emulsion Latex

Multifunctional and fluorine-free superhydrophobic composite coating based on PDMS modified MWCNTs/ZnO with self-cleaning, oil-water separation, and flame retardant properties

Multifunctional Superhydrophobic Polymer/Carbon Nanocomposites: Graphene, Carbon Nanotubes, or Carbon Black?

Hybrid Topography of Lotus Leaf under Hydrostatic/Hydrodynamic Pressure