Abstract:In the process of hot-dip galvanizing, some beneficial alloying elements are deliberately added to the molten Zn bath, in order to improve the coating properties, such as formability and corrosion resistance. Sb is one of the interesting alloying additions to the Zn bath, as it can decrease the viscosity and the surface tension of the molten Zn, contributing to producing a uniform Zn coating. Due to the low solid solubility of Sb in molten Zn at galvanising temperature, Sb-rich intermetallic particles were always found in the galvanized layers. The presence of Sb-rich phases may affect the structural properties and corrosion performance of galvanized coating. In the literature, it was reported that small addition of Sb has no significant effect on the structure and growth of galvanized layers, but a higher amount (>1%, mass fraction) of Sb can promote the dendritic solidification of Zn. In order to understand the mechanism of Sb addition on the structure and growth of galvanized coating, it is essential to identify the crystal structure of Sb-rich phases. It was reported that the Sb-rich phases found in the eta layer of a galvanized coating corresponds to the electron diffraction patterns of Sb2Zn3. However, some researchers hold that the Sb2Zn3 compound does not exist at room temperature, since it can transform to Sb3Zn4 and Zn at some elevated temperature. Consequently, in this work, the structure of Sb-rich intermetallic phase in theZn-1.2Sb (1.2%Sb) alloy has been investigated by SEM and TEM. SEM/EDS showed that Sb is present in the form of Sb-rich intermatallic phase and there is no detectable Sb in the Zn solid solution. Transmission electron diffractions analysis and EDS results indicated that the composition of Sb-rich intermatallic phases is close to that of Sb2Zn3, whereas the structure is totally different from the latter. The corrosion resistance of Zn-1.2Sb alloy has been analysed by electrochemcial polarization measurements in the different solutions. The analysed results showed that the Sb-rich phase has no obvious effect on the oxygen reduction reaction, in the aerated 0.1 mol/L NaCl (pH=6.5) solution. However, the Sb-rich phase can promote the hydrogen evolution reaction, in the deaerated acidic solution (0.1 mol/L NaCl, pH=3). Corrosion pits were found in the Zn matrix around the Sb-rich phases by SEM observations, which indicate that Zn has higher activity than Zn-Sb phase.

Corrosion Behaviour of Pb-0.05%Sb Alloy and Pb in Boiling H2SO4 Aqueous Solution

Influences of Temperature, H2SO4 Concentration and Sn Content on Corrosion Behaviors of PbSn Alloy in Sulfuric Acid Solution

Corrosion Behaviour of New Pb-Ca Alloy in Sulfuric Acid Solution

Investigation on properties of Pb-Sb-Re alloy

Effects of Sb on corrosion behavior of Mg-6Al alloy

Corrosion characterizations of Sn–9Zn–xS in acidic and alkaline solutions

Bismuth addition affecting the microstructure evolution and anti-corrosion performance of Sn-3.0Ag-0.5Cu-xBi solder alloy

Modification Research on the Influence on Corrosion Film Properties of Pb‐Ca‐Sn Alloys of with Addition of Bi, Ag and Zn

EFFECT OF Sb AND Mn ADDITIONS ON THE CORROSION BEHAVIOUR OF Zn

Effect of Sb-Rich Intermetallic Phase on the CorrosionResistance of Zn Alloy in Near-Neutral and Acidic Solutions

Anodic Behaviors of Pb-Ca-Sn-Re Alloy and Tradditional Pb-Ca-Sn Alloy in Sulfuric Acid Solutions

Effect of Antimony on the Reduction of Anodic Pbo2 Film on Pb-Sb Alloys in Sulfuric Acid Solution

New Phenomenon in the Anodic Corrosion of Lead-Antimony Alloy in Lead-Acid Batteries

Corrosion Behavior of 6061 Aluminum Alloy in Simulated SO2-Polluted Seawater

Chemical States of Corrosion Products in Liquid Lead from Ab Initio Molecular Dynamics

Effect of H3bo3 on Corrosion in 0.01 M Nacl Solution of the Interface Between Low Alloy Steel A508 and Alloy 52 M

Effect of Sn Addition on the Corrosion Performance of Cast X-52 in H<sub>2</sub>S-Containing Environment at 60°C

Corrosion behavior of various conductive materials in Sb3Sn7 alloy at 450 °C

Effect of Sn Addition on the Corrosion Performance of Cast X-52 in H2S-Containing Environment at 60°C

Comparison of the reduction behaviour of anodic PbO2 films on Pb-As and Pb-Bi alloys in sulfuric acid

The Effect of Samarium Replacing Calcium on the Anodic Behavior of Lead Alloy in Sulfuric Acid Solution