Abstract:Tight ultrafiltration (TUF) membranes with high performance have attracted more and more attention in the separation of organic molecules. To improve membrane performance, some methods such as interface polymerization have been applied. However, these approaches have complex operation procedures. In this study, a polydopamine (PDA) modified MoS2 (MoS2@PDA) blending polyethersulfone (PES) membrane with smaller pore size and excellent selectivity was fabricated by a simple phase inversion method. The molecular weight cut-off (MWCO) of as-prepared MoS2@PDA mixed matrix membranes (MMMs) changes, and the effective separation of dye molecules in MoS2@PDA MMMs with different concentrations were obtained. The addition amount of MoS2@PDA increased from 0 to 4.5 wt %, resulting in a series of membranes with the MWCO values of 7402.29, 7007.89, 5803.58, 5589.50, 6632.77, and 6664.55 Da. The MWCO of the membrane M3 (3.0 wt %) was the lowest, the pore size was defined as 2.62 nm, and the pure water flux was 42.0 L m−2 h−1 bar−1. The rejection of Chromotrope 2B (C2B), Reactive Blue 4 (RB4), and Janus Green B (JGB) in aqueous solution with different concentrations of dyes was better than that of unmodified membrane. The separation effect of M3 and M0 on JGB at different pH values was also investigated. The rejection rate of M3 to JGB was higher than M0 at different pH ranges from 3 to 11. The rejection of M3 was 98.17–99.88%. When pH was 11, the rejection of membranes decreased with the extension of separation time. Specifically, at 180 min, the rejection of M0 and M3 dropped to 77.59% and 88.61%, respectively. In addition, the membrane had a very low retention of salt ions, Nacl 1.58%, Na2SO4 10.52%, MgSO4 4.64%, and MgCl2 1.55%, reflecting the potential for separating salts and dyes of MoS2@PDA/PES MMMs.

Preparation Of Magnesium Silicate/Polyethersulfone Hybrid Ultrafiltration Membrane For Macromolecular Intercept And Dye Removal

Homogeneous Polyethersulfone Hybrid Membranes Prepared with In-Suit Synthesized Magnesium Hydroxide Nanoparticles by Phase Inversion Method

Preparation and Performance of Polyethersulfone Hollow-Fiber Membrane

Novel Polyethersulfone Hybrid Ultrafiltration Membrane Prepared with SiO2-g-(PDMAEMA-co-PDMAPS) and Its Antifouling Performances in Oil-in-water Emulsion Application

Adapting the performance and physico-chemical properties of PES nanofiltration membrane by using of magnesium oxide nanoparticles

Engineering High-Effective Antifouling Polyether Sulfone Membrane with P(Peg-Pdms-Kh570)@Sio2 Nanocomposite Via In-Situ Sol-Gel Process

Development of antifouling nanofiltration membranes for separation of dye/salt mixture through incorporation of novel polyelectrolyte-decorated silica

Zwitterionic copolymer modified polyethersulphone/sulfonated polysulphone membranes for enhancing dye/salt selective separation

Fabrication and performance evaluation of an innovative asymmetric polyethersulfone composite membrane for efficient methyl blue filtration

Tailoring the Microstructure and Properties of PES/SPSf Loose Nanofiltration Membranes Using SPES As a Hydrophilic Polymer for the Effective Removal of Dyes Via Steric Hindrance and Charge Effect

Microporous Polyethersulfone Membranes Prepared under the Combined Precipitation Conditions with Non-Solvent Additives

Hydrophilic and Anti-Fouling Polyethersulfone Ultrafiltration Membranes with Poly(2-Hydroxyethyl Methacrylate) Grafted Silica Nanoparticles As Additive

Anti-Fouling and Anti-Bacterial Polyethersulfone Membranes Quaternized from the Additive of Poly(2-Dimethylamino Ethyl Methacrylate) Grafted Sio2 Nanoparticles

Polyethersulfone Microfiltration Membrane Modified by an Amphiphilic Dithiolane‐containing Copolymer for Improving Anti‐protein‐fouling Performance and Rejection of Nanoparticles

Hydrophilic Microporous PES Membranes Prepared by PES/PEG/DMAc Casting Solutions

Preparation and Characterization of Novel Polyether Sulphone Ultrafiltration Membranes

Facile membrane preparation strategy to reinforce permeability of polyethersulfone (PES) micro-ultrafiltration membrane for drinking water treatment

Antifouling enhancement of poly(vinylidene fluoride) microfiltration membrane by adding Mg(OH)2 nanoparticles

Designing of a novel polyethersulfone (PES) ultrafiltration (UF) membrane with thermal stability and high fouling resistance using melamine-modified zirconium-based metal-organic framework (UiO-66-NH2/MOF)

Polydopamine-Assisted Two-Dimensional Molybdenum Disulfide (MoS2)-Modified PES Tight Ultrafiltration Mixed-Matrix Membranes: Enhanced Dye Separation Performance

Improved Protein Removal Performance of PES Hollow-Fiber Ultrafiltration Membrane with Sponge-like Structure