Activation Analysis of Coolant in a Water-Cooled Loop of China Fusion Engineering Test Reactor

Qingyang Guo,Jingyu Zhang,Sheng Fang,Yixue Chen

DOI: https://doi.org/10.1016/j.fusengdes.2018.03.059

IF: 1.905

2018-01-01

Fusion Engineering and Design

Abstract:In the design scheme of China Fusion Engineering Test Reactor (CFETR), water will be adopted as the coolant in some cooling loops. The water itself and the impurities in it will be activated by neutrons, and the activation products 16N, 17N, 3H and 14C are important to the occupational radiation exposure (ORE) during operation and maintenance. In this paper, two analysis models (homogeneous model and two-node model) are developed to calculate the radioactivity of activation products in the water-cooled loop. Then, the impact of water chemistry parameters (pH and 7Li abundance) on tritium production is analyzed. At last, the dose rate of one typical blanket water-cooled loop is calculated using the point kernel code ARShield. The results show that: (1) the radioactivity of short-lived nuclides 16N and 17N is obviously affected by coolant flow and the results from the two-node model considering coolant flow are more conservative; (2) the radioactivity of long-lived nuclides 3H and 14C is obviously affected by purification; (3) 16N and 17N are the main contributors to radioactivity, whose radioactivity are several orders of magnitude higher than that of 3H and 14C; (4) tritium is susceptible to water chemistry environment, and at pH of 7.1 tritium radioactivity is about two orders of magnitude higher than that at pH of 5.7; (5) at pH of 7.1, the contribution of lithium to tritium production increases linearly with increase of 7Li abundance in LiOH in the water.