Abstract:A proton exchange membrane (PEM) fuel cell is one of the highly efficient hydrogen utilization devices. However, due to the complex physical and chemical processes in fuel cells, developing a mathematical model of the PEM fuel cell is challenging. In this study, a new coupled model based on the computational fluid dynamics method and a 1D model is proposed for the accurate and fast prediction of PEM fuel cell performance. First of all, the proposed model is validated using the literature data. It is then applied to simulate the distribution and evolution of the current density, hydrogen and oxygen mass fraction, and membrane water content in catalyst layer (CL). Results show that the increase in the current density is attributed to the increase in the consumption rate of hydrogen and oxygen and the increase in the membrane water content. In addition, the stabilized supply of the oxygen in cathode and the membrane water content in the anode CL are critical for the improvement of the fuel cell performance. For the cases studied in this research, when the output voltage decreases from 0.6 V to 0.3 V, the current density increases from 5738.1 A/m2 to 15171.2 A/m2. The average oxygen mass fraction in the cathode CL and the average membrane water content in the anode CL decreased by 42.3 % and 9.6 %, respectively. In addition, when the fuel cell starts up at 0.6 V, the concentration of hydrogen and oxygen drops gradually decreases along the flow direction of the CL, while the membrane water content rapidly increases initially, and then increases slowly, with the turning point around at approximately 2.2 x 10-3 m. Under the combined effect of hydrogen and oxygen concentration, as well as the membrane water content, the current density first increases and then decreases, with the maximum value exceeding 6500 A/m2.

Improved Methods to Measure Hydrogen Crossover Current in Proton Exchange Membrane Fuel Cell

Hydrogen Crossover Current and Electronic Resistance Detection in a PEM Fuel Cell

A general equation for the polarization curves of proton exchange membrane fuel cell under hydrogen crossover current measurement

Review of hydrogen crossover through the polymer electrolyte membrane

Use of galvanostatic charge method as a membrane electrode assembly diagnostic tool in a fuel cell stack

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

Hydrogen crossover measurement and durability assessment of high-pressure proton exchange membrane electrolyzer

Hydrogen pumping activation and galvanostatic charge measurement for PEMFC

Recent progress in the use of electrochemical impedance spectroscopy for the measurement, monitoring, diagnosis and optimization of proton exchange membrane fuel cell performance

Simultaneous Measurement of Current and Temperature Distributions in a Proton Exchange Membrane Fuel Cell

Investigation of real-time changes and recovery of proton exchange membrane fuel cell in voltage reversal

Model-based estimation of liquid saturation in cathode gas diffusion layer and current density difference under proton exchange membrane fuel cell flooding

Experimental investigation of operating characteristics of proton exchange membrane fuel cell with different anode strategies based on the segmented cell

A Coupled CFD Model for an Accurate and Fast Prediction of the Unsteady Operation Process of a Proton Exchange Membrane Fuel Cell

Analytical Calculation and Evaluation of Water Transport Through a Proton Exchange Membrane Fuel Cell Based on a One-Dimensional Model

In-situ Characterization of Gas Distribution in Proton Exchange Membrane Fuel Cell Stacks

An advanced 1D physics-based model for PEM hydrogen fuel cells with enhanced overvoltage prediction

Study of Internal Multi-Parameter Distributions of Proton Exchange Membrane Fuel Cell with Segmented Cell Device and Coupled Three-Dimensional Model

Implementation and optimization of perturbation currents for vehicular proton exchange membrane fuel cells online electrochemical impedance spectroscopy measurements

Diagnosis of Water Failures in Proton Exchange Membrane Fuel Cell with Zero-Phase Ohmic Resistance and Fixed-Low-frequency Impedance

In-situ Measurement of Temperature and Humidity Distribution in Gas Channels for Commercial-Size Proton Exchange Membrane Fuel Cells