Abstract:Water concentration inside proton exchange membrane fuel cells (PEMFCs) is a key factor affecting performance and durability. Therefore, many studies have been conducted to maintain an appropriate moisture balance inside the stack. The most recent study was a study that confirmed moisture distribution using five sensors inside the anode and cathode. However, in this study, it is difficult to determine the exact moisture distribution inside the stack due to insufficient sensors. In this study, a unit cell PEMFC including micro relative humidity and temperature (RH/T) sensors with an active area of 100cm 2 was fabricated to characterize the water concentration. Before installing the micro sensors into the bipolar plates, a reliability test is conducted, and the result shows that the sensor is reliable at 60 °C and 70 °C. After that, for the in-situ temperature and relative humidity measurement, the 50 sensors are installed along the anode and cathode gas channels evenly in the active area. This study investigates the distribution of water transport behavior, temperature, and water concentration at 0.6 V, 0.5 V and 0.4 V of electric load. Dew point is introduced to analyze water concentration, and net water mole flux is calculated to evaluate water transport behavior. The results show that as the load applied to the PEMFC increases, higher temperature band expands from downstream to upstream of the gas flow. In addition, at 0.4 V, observing the highest temperature band between 61 °C to 62 °C, it is concluded that the flow field of the reaction zone is more activated along the downstream. Meanwhile, the anode becomes more dehydrated with higher load and the cathode more hydrated. At 0.4 V, the maximum dew point on the cathode is 37.5 °C, and the minimum dew point on the anode is 30 °C. In conclusion, even though water transports from the cathode to the anode, due to dry inlet gas, 20% of relative humidity, and high flow rate, hydrogen by 2.8lpm and air by 6.65lpm, the anode doesn't become hydrated.

Hydrogen pumping activation and galvanostatic charge measurement for PEMFC

Use of galvanostatic charge method as a membrane electrode assembly diagnostic tool in a fuel cell stack

Activation of polymer electrolyte membrane fuel cells: Mechanisms, procedures, and evaluation

Improved Methods to Measure Hydrogen Crossover Current in Proton Exchange Membrane Fuel Cell

Dynamic evolutions of local current density and water–gas distribution of proton exchange membrane fuel cell with dead-ended anode

Optimization of the activation condition of a PEM fuel cell for automotive

Operation Parameters of Air-Cooled Fuel Cell Based on In-Situ Testing of Reaction State

Dynamic Characteristics and Mitigations of Hydrogen Starvations in Proton Exchange Membrane Fuel Cells During Start-Ups

Activation Methods and Underlying Performance Boosting Mechanisms Within Fuel Cell Catalyst Layer

Investigation of real-time changes and recovery of proton exchange membrane fuel cell in voltage reversal

Initial research on the activation process for a PEMFC: Phenomenon analysis

Current density and temperature distribution measurement and homogeneity analysis for a large-area proton exchange membrane fuel cell

Performance Analysis of Automotive Fuel Cell During Activation Period

Hydrogen Pumping Effect Induced by Fuel Starvation in A Single Cell of A Pem Fuel Cell Stack at Galvanostatic Operation

Mitigation Strategies for Hydrogen Starvation under Dynamic Loading in Proton Exchange Membrane Fuel Cells

Hydrogen crossover measurement and durability assessment of high-pressure proton exchange membrane electrolyzer

Optimization strategies to mitigate reactant starvation in a dead-ended hydrogen–oxygen proton exchange membrane fuel cell during cyclic loading

Dynamic Performance of a High-Temperature PEM Fuel Cell – an Experimental Study

Recovery characteristics of reversible degradation for proton exchange membrane fuel cell stack under accelerated stress test

Multiple in-situ measurement of water transport in the bipolar plate of proton exchange membrane fuel cell

Dynamic Characteristics of Internal Current During Startups/shutdowns in Proton Exchange Membrane Fuel Cells