Experimental study on changes of pore structure and mechanical properties of sandstone after high-temperature treatment using nuclear magnetic resonance
Min Li,Deming Wang,Zhenlu Shao
DOI: https://doi.org/10.1016/j.enggeo.2020.105739
IF: 6.902
2020-09-01
Engineering Geology
Abstract:Variations of the mechanical properties and the pore structures of rocks after high-temperature treatment play a significant role in ensuring the operation of underground coal gasification and prevent the pollution of groundwater. In this study, to quantitatively analyse the pore structure and mechanical properties of sandstone after treatment at different temperatures (25 °C, 100 °C, 200 °C, 300 °C, 400 °C, 500 °C, 600 °C, 700 °C, 800 °C, and 900 °C), an experiment was conducted based on nuclear magnetic resonance. The variation laws of the size and number of pores in sandstone after the high-temperature treatment were determined to investigate the development of cracks and the changes in the mechanical properties of the rock. At low temperatures, micropores account for over 90%, and the connectivity between pores and cracks is poor. In the temperature range of 200–500 °C, macropores and microcracks were found to increase the most, followed by mesopores, while micropores exhibited the smallest increase. Above 600 °C, the porosity and permeability of the sandstone improved significantly. Furthermore, the porosity and permeability increased sharply by 1.62 and 1.27 times, respectively, at 500–600 °C compared with those at room temperature. After the high-temperature treatment, the stress-strain curves of sandstone gradually became smoother, the post-peak residual stress intensified, and the brittleness weakened. The inflection point of sandstone strength occurs at 800 °C, which lags behind the porosity, permeability, and peak strain, because the trans-granular cracks penetrate the whole granule and connect with the surrounding fracture network.