Abstract:In the study, an interrupting performance test on the 145 kV gas circuit breaker is performed according to three different gases: SF6, g3 (5% NovecTM4710 with 95% CO2), and CO2(70%)/O2(30%) gases. Thanks to research advancements, it is confirmed that CO2 and g3 (5% NovecTM 4710) gases, respectively, have 40% and 75% dielectric strength, compared to that of SF6 gas. The filling pressure and transient recovery voltage criteria of each gas were determined differently in order to compare the maximum interrupting performance of each gas. The pressure of SF6 gas was determined to be 5.5 bar, which is typically used in circuit breakers. The pressure of the other two gases was determined to be 8.0 bar (the maximum available pressure of the test circuit breaker) to find the maximum interrupting performance. Moreover, the rate-of-rise of transient recovery voltage of SF6 was determined as 10 kV/μs, which is the value at the state of maximum interrupting performance of the test circuit breaker with SF6. On the other hand, the rate-of-rise of transient recovery voltages of g3 (5% NovecTM4710 with 95% CO2) and CO2(70%)/O2(30%) gases were, respectively, determined as 4∼5 kV/μs to find the interruption available point. The characteristics of arc conductance, arc current, and arc voltage near the current zero, and post-arc current are analyzed to compare the interrupting performance, according to different arc-quenching gases. The arc current is measured using a current transformer (Rogowski coil), and a signal processing method of the arc current and arc voltage is introduced to increase the reliability of the interrupting performance results. As a result of the test, it is confirmed that the critical arc conductance for all test conditions converged within a certain range and the value is around 0.7 mS. In addition, the critical current slope just before the current zero-crossing during the interrupting process is shown to be 1.8 A/μs between interruption success and failure. Consequently, it is verified that the CO2(70%)/O2(30%) mixture and g3 (5% NovecTM4710 with 95% CO2) have a similar arc extinguishing performance and SF6 has a relatively higher extinguishing performance than that of CO2(70%)/O2(30%) mixture and g3 (5% NovecTM4710 with 95% CO2) under the aforementioned filling pressure and TRV conditions.

Arc Temperature Profile Measurement and Characteristic Analysis on an SF 6 High-Voltage CB

Arc Shape and Arc Temperature Measurements in SF6 High-Voltage Circuit Breakers Using a Transparent Nozzle

Measurement of Arc Temperature in Nozzle of SF6 Circuit Breaker During Heavy Current Interruptions

Characteristics Analysis Of Arc Temperature In Sf6 Circuit Breaker

Pressure Measurement and Characteristic Analysis on a 252-Kv Puffer-Type SF $_{6}$ Circuit Breaker

Interrupter Pressure Measurement of a 252 Kv SF6 Circuit Breaker

Arc temperatures in a circuit breaker experiment from iterative analysis of emission spectra

Mass spectrometry of arcs in SF6 circuit breakers

Influence of DC Component Time Constants on Asymmetrical Fault Interruption of 126 kV SF 6 Circuit Breakers

Investigation of Arc Characteristics of a DC Vacuum Circuit Breaker With Double-Break Under Asynchronous Interrupting

Application of arc breaking simulation in development of extra high voltage SF<sub>6</sub> circuit breaker

Optical Diagnostics of Vacuum Arc in the process of DC Interruption

Pressure Measurement in SF6 Circuit Breaker's Nozzle in Heavy Current Interruption

Interruption Characteristic of 3%C5F10O/97%CO2 Gas Mixture in a 40.5kV Circuit Breaker

Analysis of Breaking Characteristics of C4F7N/CO2 Mixture Gas in Circuit Breaker

Comparison of the Interrupting Capability of Gas Circuit Breaker According to SF6, g3, and CO2/O2 Mixture

Parametric characterization of arcs in semi-sealed splitter plate DC circuit breakers

Study on the effect of arc chamber structures on the post-arc characteristics of generator circuit breaker

Fault Arc Modeling and Analysis in Circuit Breaker in HVDC Converter Station Filter Branch

Study of Arc Interruption Characteristics under Rated Current in Low Voltage Circuit Breakers

Investigation of the Arc Characteristics in a Nozzle with C4F7N/CO2 Mixtures