Abstract:The microstructural evolution and mechanical properties of cast high-Li-content TiB2/Al-Li-Cu composite during heat treatment were systematic investigated by a combination of various techniques, including transmission electron microscopy (TEM) with HAADF-STEM mode, electron backscatter diffraction (EBSD), scanning electron microscopy (SEM) and differential scanning calorimetry (DSC). The coarse secondary phases, mixed with clusters of relatively larger TiB2 particles, distributed along grain boundaries were observed in as-cast state. And most of them dissolved into the α-Al matrix after a two-stage solution treatment. The grain size of the studied composite exhibited excelled thermal stability owing to effective pinning grain boundaries by the stable particles at the elevated temperature, resulting in no significant increase after solution treatment. The studied composite showed a strong age-hardening response with the peak-hardness was obtained in about 160 h at 175 °C. TEM results showed much fine δ′ precipitates were uniformly distributed within grains after quenching and it coarsened with the increasing age duration. Fine plate-like θ′ and T1 precipitates were observed in the under-aged (UA, aged for 8 h) condition. The rate of precipitation and growth in its diameter was much greater than its coarsening rate, resulted in the large aspect ratio and high number density of T1 and θ′ precipitates were visible in the peak-aged (PA) condition. Finally, a slight decline in hardness was observed in the over-aged (OA) condition due to the apparent coarsening of θ′ and T1 precipitates. This precipitation behavior was further verified by DSC. After appropriate heat treatment, a good comprehensive mechanical properties could be obtained in the composite.

Effects of TiB 2 particles on artificial aging response of high-Li-content TiB 2 /Al-Li-Cu composite

Effects of TiB 2 particles on aging behavior of in-situ TiB 2 /Al–Cu–Mg composites

The Influence of TiB2 Particles on the Artificial Aging Behavior of TiB2/Al–5Cu Composite

Effects of TiB2 Particles on Microstructure and Mechanical Properties of an In-Situ TiB2-Al–Cu–Li Matrix Composite

Effects of Nanosized Particles on Microstructure and Mechanical Properties of an Aged In-Situ TiB2/Al-Cu-Li Composite

Precipitation Behavior of the High-Li-content In-Situ TiB2/Al-Li-Cu Composite

Microstructural evolution and mechanical properties of cast high-Li-content TiB 2 /Al-Li-Cu composite during heat treatment

Aging Behavior of &Lt;i>in-Situ</i> TiB<sub>2</sub> Particles Reinforced 2014al Alloy Composites

Aging behavior of an in-situ TiB2/Al-Cu-Li-x matrix composite

Microstructures, mechanical properties, and aging behavior of hybrid-sized TiB2 particulate-reinforced 2219 aluminum matrix composites

Effect of TiB2 particles on thermal deformation behavior and mechanical properties of aluminum alloy

Microstructural evolution and hydrogen content and their effect on properties of TiB 2 /Al-Li-X composites with different Li contents

Processing, microstructure and ageing behavior of in-situ submicron TiB2 particles reinforced AZ91 Mg matrix composites

Effect of Ti content on microstructures and mechanical properties of cast Al-2Li-2Cu-0.5Mg alloy

Enhancing strength-ductility synergy in nano-sized TiB 2 /Al composite via rapid solidification and thermo-mechanical processing

Effect of TiB2 on Microstructure, Mechanical Properties and Oxidation Resistance of TiAl-based Alloys

Impact behavior of in situ TiB<sub>2</sub>/Al composite at various temperatures

Insight into the recrystallization behavior and precipitation reaction of in-situ nano TiB2/AlCuMg composite during heat treatment

Impact behavior of in situ TiB 2 /Al composite at various temperatures

Effect of In-Situ TiB2 Particles on the Creep Properties of 3 Wt.% TiB2/Al-Cu-Mg-Ag Composite

Insight into the recrystallization behavior and precipitation reaction of in-situ nano TiB2/Al Cu Mg composite during heat treatment