Abstract:In present study, the creep behavior of (TiB + TiC+Y2O3)/α-Ti composite with C-1 and C-2 microstructure were investigated with applied stress of 200 MPa and at 650–700 °C. The steady state creep rate increased by an order of magnitude from 650 °C to 700 °C, and the C-2 microstructure shown worse creep performance compared to C-1 microstructure. The creep activation energy of C-1 and C-2 microstructure were 359.5 kJ/mol and 380.2 kJ/mol, respectively, which were higher than the lattice diffusion in α-Ti. And the less QG due to coarse microstructure was responsible for its higher creep activation energy in C-2. In addition to cracks were observed at β grain boundary, α colony boundary, α/β phase boundary, they were also observed near the fracture TiB whiskers and near decohesion reinforcements. The cracks in C-2 were mainly concentrated near the reinforcement, while those in C-1 were mainly concentrated in the matrix part. Further analysis confirmed that the creep deformation mechanism of C-2 microstructure was controlled by reinforcements, but the creep deformation mechanism of C-1 microstructure was controlled by matrix microstructure. Summarily, the effect of reinforcement on creep deformation of (TiB + TiC+Y2O3)/α-Ti composite could be divided in two aspect: microstructure influence and the reinforcement itself. For reinforcement itself, it indeed affected the dislocation movement and creep fracture behavior, and then improved the creep performance. However, for microstructure influence, the fine grain (more grain boundary), coarsen microstructure (more equiaxed characteristics of α lamellar) caused more grain boundary slip to participate in creep deformation, which in turn deteriorated creep performance. In this study, the latter effect was somewhat bigger.

Effect of In-Situ TiB2 Particles on the Creep Properties of 3 Wt.% TiB2/Al-Cu-Mg-Ag Composite

Significantly Enhanced Creep Resistance of Low Volume Fraction In-Situ TiBw/Ti6Al4V Composites by Architectured Network Reinforcements

Constructing Two-Scale Network Microstructure with Nano-Ti5si3 for Superhigh Creep Resistance

Effect of TiB_2 content on microstructure and mechanical properties of in-situ fabricated TiB_2/B_4C composites

In Situal3ti–al2o3 Intermetallic Matrix Composite: Synthesis, Microstructure, and Compressive Behavior

High Temperature Tensile Properties of in Situ TiBw/Ti6Al4V Composites with a Novel Network Reinforcement Architecture

Short-time creep behavior of (TiB + TiC + Y2O3) reinforced titanium matrix composite in the range of 600 °C to 700 °C

The role of TiB2 particles in the creep and penetrating resistance of graphite-based composite

High temperature performance of TiB/(Ti-6.5Al-2Zr-1Mo-1V-0.5Si) composites affected by the TiB architecture

Study on the Effect of Micromorphology and Creep Properties of In Situ (ZrB2 + Al2O3)/AA6016 Composites in Extruded State

The creep behavior of (TiB + TiC + Y2O3)/α-Ti composites at high temperature and short-term

Effect of TiB2 particles on thermal deformation behavior and mechanical properties of aluminum alloy

The Influence of TiB2 Particles on the Artificial Aging Behavior of TiB2/Al–5Cu Composite

Enhanced high temperature mechanical properties and heat resistance of an Al–Cu–Mg–Fe–Ni matrix composite reinforced with in-situ TiB2 particles

Microstructural evolution and mechanical properties of TiB2/2195 composites fabricated by ultrasonic-assisted in-situ casting

Effect on microstructure and mechanical properties of in situ 6 wt%TiB2/Al–Zn–Mg–Cu composite subjected by two-step orthogonal deformation process

High Strain Rate Response of In-Situ TiB2/7055 Composite by Taylor Impact

Effect of Mg on the microstructure evolution and mechanical properties of 5%TiB2/Al−4.5%Cu composites

Insight into the recrystallization behavior and precipitation reaction of in-situ nano TiB2/Al Cu Mg composite during heat treatment

Investigation on peripheral coarse grains and precipitation behavior of in-situ TiB2/Al–Cu–Mg composites with various Mg contents

Superplasticity of Al-Zn-Mg-Cu composite containing uniform TiB2 nanoparticles