Abstract:If inherently intermittent renewable energy technologies are to offer a practical alternative to conventional heat engines, it is critically important that efficient, cost-effective and sustainable energy storage solutions are developed to decouple supply and demand profiles. A promising strategy is to pair the competitive energy densities of batteries with the superior cycling lifetimes and power densities of supercapacitors,[1] employing an appropriate maximum power point tracking (MPPT) system to optimise energy exchange between these complementary devices.[2] Mixed-valence manganese(III/IV) oxides (MnO z , where z ranges between 1.5 and 2.0) have emerged as foremost candidates for the electroactive material in supercapacitor cathodes due to their low toxicity, minimal cost,[3] ready availability (manganese appears at an average concentration of ca . 1,000 ppm in the Earth’s crust[4]), wide electrochemical stability window ( ca . 1.0 V in aqueous electrolytes[5]), and high maximum theoretical specific capacitance ( ca . 1,370 F g -1 , based on the reduction of Mn 4+ ions by a single electron[6]). Charge storage in MnO z is predominantly mediated by the pseudocapacitive intercalation of cations from the surrounding electrolyte in each discharge phase, followed by the release of these guest ions during charging. Of the various crystallographic phases of MnO z , cryptomelane (α-MnO z ) and birnessite (δ-MnO z ) polymorphs are deemed two of the most promising candidates for storage applications because they possess characteristically wide channels for intercalation/de-intercalation:[8,9] α-MnO z consists of ca . 4.6 Å diameter one-dimensional tunnels enclosed between corner-sharing MnO 6 octahedra, whereas δ-MnO z comprises two-dimensional layers of MnO 6 octahedra separated by ca . 7.0 Å. Herein, a scalable, low-cost synthesis procedure is discussed that enables the production of highly pseudocapacitive birnessite and cryptomelane electrodes with tuneable material characteristics, including particle morphology, crystallographic structure, average Mn oxidation state, and the level of pre-intercalation by Na + and K + ions.[10] In addition to comparing the electrochemical properties of these Na x K y MnO z products in aqueous conditions, their application within an asymmetric supercapacitor is showcased: by optimising the relative masses of a Na x K y MnO z cathode and activated carbon anode in a 100 cm 2 aqueous full-cell configuration, discharge capacitances in the range 10-30 F g -1 can be achieved over a voltage span of 1.8 V at current densities as high as 10 A g -1 , with Coulombic efficiency exceeding 80% up to ca . 20 A g -1 . With these competitive performance characteristics, the developed Na x K y MnO z materials are a promising option for high-power supercapacitor cathodes, helping to pave the way towards more efficient and sustainable energy storage. References [1] Babu, B.; Simon, P.; Balducci, A. Adv. Energy Mater ., 2020 , 10 , e2001128. [2] Jing, W.; Lai, C. H.; Wong, W. S. H.; Wong, M. L. D., Sustain. Energy Technol. Assess ., 2017 , 22 , 55–64. [3] Narayanan, T. M.; Zhu, Y. G.; Gençer, E.; McKinley, G.; Shao-Horn, Y., Joule , 2021 , 5 , 2934–2954. [4] Hurd, A. J.; Kelley, R. L.; Eggert, R. G.; Lee, M. H., MRS Bull ., 2012 , 37 , 405– 410. [5] Xie, J.; Liang, Z.; Lu, Y. C., Nat. Mater ., 2020 , 19 , 1006–1011. [6] Toupin, M.; Brousse, T.; Bélanger, D., Chem. Mater ., 2004 , 16 , 3184–3190. [7] Guo, W.; Yu, C.; Li, S.; Wang, Z.; Yu, J.; Huang, H.; Qiu, J., Nano Energy , 2019 , 57 , 459–472. [8] Samal, R.; Chakraborty, B.; Rout, C. S., J. Appl. Phys ., 2019 , 126 , e045112. [9] Ghosh, S. K., ACS Omega , 2020 , 5 , 25493–25504. [10] Jones, D. R.; Hussein, H. E. M.; Worsley. E. A.; Kiani, S.; et al., ChemElectroChem , 2023 , 10 , e202300210. Figure 1

Influence of Calcium Doping on Performance of LaMnO3 Supercapacitors

Stacking Fault Disorder Induced by Mn Doping in Ni(OH)2 for Supercapacitor Electrodes

Enhanced Electrochemical Performance of LaMnO3 Nanoparticles by Ca/Sr Doping

Manganese Oxide-Based Electrode Behavior As Materials for Electrochemical Supercapacitors

Manganese Doped Co3O4 Mesoporous Nanoneedle Array for Long Cycle-Stable Supercapacitors

Al-doped α-MnO 2 for high mass-loading pseudocapacitor with excellent cycling stability

Study on different power and cycling performance of crystalline K xMnO 2·nH 2O as cathode material for supercapacitors in Li 2SO 4, Na 2SO 4, and K 2SO 4 aqueous electrolytes

Effect of A-Site Substitution on LaMnO3 Perovskite via Sr Ions for Energy Applications

Doping Effect and Oxygen Vacancy Engineering in Nickel-Manganese Layered Double Hydroxides for High-performance Supercapacitors

Influence of fluorine doping on the structure and electrochemical performance of δ-MnO2 for supercapacitors

Enhanced Reaction Kinetics of N–MnO 2 Nanosheets with Oxygen Vacancies via Mild NH 3 ·H 2 O Bath Treatment for Advanced Aqueous Supercapacitors

Synthesis and Characterization of Nickel-doped Manganese Dioxide Electrode Materials for Supercapacitors

Effect of Cr doping on Mn3O4 thin films for high-performance Supercapacitors

Preparation Of Carbon cloth/MnO2 Doped with Different Metal Ions for Supercapacitor Electrode

Unlocking the optimum supercapacitance of Co3O4 by reducing the Co valence state via Mn doping

Tailoring Electrochemical Performance of Co3O4 Electrode Materials by Mn Doping

Mo doping V0.76Mn0.032Ni0.029O2 vanadium based ternary metal oxides as cathode active materials for lithium-ion hybrid supercapacitor with high lithium storage performance

Co-doped MnO2 with abundant oxygen vacancies as cathode for superior aqueous magnesium ion storage

La0.75Sr0.25Cr0.5Mn0.5O3 perovskite developed for supercapacitor applications

Mg doping NiMn-LDH with three-dimensional porous morphology for efficient supercapacitor

Tuning the Composition, Crystal Structure and Morphology of Manganese(III/IV) Oxide for High-Power Storage Applications