Abstract:Lignite is considered as an raw energy material with abundant supply worldwide. However, power plants that directly fire lignite exhibit low efficiency, which can be improved by applying lignite pre-drying technologies. Lignite-Fired power plants integrated with a steam or flue gas dryer (SPLPS or FPLPS) are designed and optimized. Previous studies mainly focused on the thermodynamic performance and techno-economic analyses of single drying technology. However, sensitivity analyses of parameters are disregarded in the techno-economic analysis. Therefore, system configurations are optimized in this study, and different drying technologies are subsequently compared on the basis of their techno-economic performance. Moreover, the sensitivity analyses of key parameters are investigated. Optimization results show that the steam extraction pressure of SPLPS should not be substantially low, and optimum extraction should be performed at steam turbine 4# regenerative extraction (0.9539 MPa, 360.9 degrees C) or 5# (0.3758 MPa, 249.6 degrees C). This approach differs from the thermodynamic performance presented in previous studies. Moreover, the detailed optimization strategy of SPLPS is realized on the basis of net present value (NPV) and payback period. The comparison results show that the maximum NPV of FPLPS would be 9.5 million USD more than the earnings from a conventional lignite-fired power system (CLPS), whereas that of SPLPS would be 40.1 million USD more than the earnings from CLPS. However, the economic benefits of FPLPS and SPLPS can be reversed with the fluctuation of parameters based on sensitivity analyses.

Thermodynamic and Economic Analysis on a Two-Stage Predrying Lignite-Fueled Power Plant

Energy Analysis of a Lignite-Fueled Power Plant with a Two-Stage Predrying System

Energy Analysis of a Lignite Predrying Power Generation System with an Efficient Waste Heat Recovery System

A Combined-Type Fluid-Bed Dryer Suitable for Integration Within a Lignite-Fired Power Plant: System Design and Thermodynamic Analysis

Thermodynamic analysis of pre-drying methods for pre-dried lignite-fired power plant

Energy And Exergy Analyses Of A Lignite-Fired Power Plant Integrated With A Steam Dryer At Rated And Partial Loads

Thermodynamic Analysis on A Pre-Dried Lignite-Fired Power System: Comparison on Energy Supply Systems for Dryer

Investigation on a new lignite predrying power generation system combined with a front air heater

Thermodynamic Analysis and Economic Evaluation of a 1000 MW Bituminous Coal Fired Power Plant Incorporating Low-Temperature Pre-Drying (LTPD)

Thermodynamic Analysis on A Lignite-Fired Power System Integrated with A Steam Dryer: Investigation on Energy Supply System of the Dryer

Thermodynamic Analysis and Case Study of a New Lignite-Fired Power Plant Using Solar Energy As Drying Heat Source

Thermodynamic Analysis of an Improved Flue Gas Pre-Dried Lignite-Fired Power System Integrated with Water Recovery and Drying Exhaust Gas Recirculation

A Novel Lignite-Fired Power Plant Integrated with A Vacuum Dryer: System Design and Thermodynamic Analysis

System Design and Theoretical Analysis of Lignite-fired CHP Based on Lignite Pre-drying and Waste Heat Recovery from Dryer Exhaust

Thermodynamic Study on a Novel Lignite Poly-Generation System of Electricity-Gas-tar Integrated with Pre-Drying and Pyrolysis

Theoretical Study of Lignite-Fired Power System Integrated With Heat Pump Drying

Theoretical Study and Case Analysis for a Predried Lignite-Fired Power System

Techno-economic Analysis of the Lignite-Fired Power Plant Integrated with a Steam or Flue Gas Dryer

Simulation Study on Lignite-Fired Power System Integrated with Flue Gas Drying and Waste Heat Recovery – Performances under Variable Power Loads Coupled with Off-Design Parameters

A novel lignite pre-drying system integrated with flue gas waste heat recovery at lignite-fired power plants

Energy Analysis of Low-Rank Coal Pre-Drying Power Generation Systems