Abstract:Bamboo-concrete composite (BCC) beams are newly-innovated products used for floor system which synergistically utilizes bamboo and concrete components. These composite beams at cur-rent technology belong to the beam characterized with partial composite action due to the ex-istence of relative slip between bamboo segment and concrete slab. Existing investigations have demonstrated that the load bearing capacity of BCC beams depends on their bending stiffness; however, very limited prediction models are available to accurately estimate the bending stiffness of BCC beams. At present, the bending stiffness of BCC beams is predicted with the help of gamma-method in Eurocode 5-Part 1-1, and available studies have demonstrated that this method overestimates the bending stiffness of BCC beams. To this end, this paper presents a novel explicit model characterized with mechanism and data mining to predict the bending stiffness of BCC beams under short-term loads. Three steps were performed to achieve the aforementioned research objective. The first step was to introduce the axial force transfer coefficient into the equilibrium equations of internal force for bamboo segment and concrete slab. Secondly, the bending stiffness of BCC beams was established by taking into account the effect of relative slip with the help of existing experimental results from the interfacial shear test and flexural test. Finally, the proposed model was validated by comparing with flexural performance results of BCC beams collected from available literature as well as those obtained from gamma-method. The comparative results show that: i) the predicted bending stiffness of BCC beams is much closer to tested ones compared with gamma-method; ii) the errors of proposed model predicting the bending stiffness for most BCC beams are within 10% of test results; however, nearly half of the predicted ones using gamma-method have errors exceeding 10% of test results, both of which verify that the mechanism and data mining-dual driven model receives a better prediction for short-term bending stiffness of BCC beams.

An Inelastic Model for Analyzing Intermediately Slender Engineered Bamboo/Wood Columns Subjected to Biaxial Bending and Compression

Experimental Studies on Glubam Columns under Axial Compression

Improvement of hysteretic constitutive model for reinforcements considering buckling

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

Bending Stiffness of Bamboo-Concrete Composite (BCC) Beams under Short-Term Loads

Axial Compression Behaviour of Bamboo-Wood Composite Columns Fabricated with Glubam and Laminated Veneer Lumber

EXPERIMENTAL STUDIES OF GLUBAM COLUMNS UNDER AXIAL LOADS

The Flexural Behavior of Cross Laminated Bamboo and Timber (CLBT) and Cross Laminated Timber (CLT) Beams

Finite Element Analysis Model for Reinforced Concrete Columns Subjected to Biaxial Eccentric Compression

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Behavior and strength of rectangular bamboo scrimber columns with shape and slenderness effects

Experimental and theoretical study on axial compression behavior of cold-formed thin-walled steel-bamboo scrimber composite columns

Influence of slenderness ratio and sectional geometry on the axial compression behavior of original bamboo columns

Slenderness Ratio Effect on Eccentric Compression Properties of Parallel Bamboo Strand Lumber Columns

Axial compressive performance of laminated bamboo column with aramid fiber reinforced polymer

Effects of Cross-Section Morphology, Vascular Bundle Content and Anisotropy on Compression Failure of Laminated Bamboo Columns

Mechanical behavior of laminated bamboo–timber composite columns under axial compression

Nonlinear modeling of bamboo fiber reinforced composite materials

Prediction of Critical Buckling Load on Open Cross-Section Columns of Flax/PLA Green Composites

Micromechanical Modeling in Determining the Transverse Elastic Moduli and Stress Distributions of Bamboo

Model for Inelastic Biaxial Bending of Concrete Members