Abstract:Abstract The axial compressive bearing capacity, failure modes, and failure mechanisms of carbon fiber-reinforced aluminum laminate (CARALL) columns with single-channel cross sections were studied in detail. In this study, two types of short CARALL specimens with a 5/4 configuration were first fabricated using 2024-T3 aluminum alloy and different fiber orientations ([0°/90°/0°] 3 , [45°/0°/−45°] 3 ) via a pressure-molding thermal-curing forming process. The short CARALL columns were then subjected to static loading tests to determine their axial compressive behaviors in terms of ultimate bearing capacity and failure modes. Thereafter, the user-defined FORTRAN subroutine VUMAT, which is based on ABAQUS, was used to investigate the failure mechanism of the proposed CARALL columns. Meanwhile, based on the classic laminated panel mechanics theory, a theoretical method was proposed to predict the safe bearing capacity of the designed compressive CARALL columns. The results indicated that the ultimate failure of both types of short CARALL columns was a strength failure caused by the delamination of the layers. When the short CARALL columns were subjected to an axial compressive load, the fiber spread angle of the carbon fiber-reinforced polymer prepregs in the laminate panels had a significant influence on the resistance to interlaminar delamination. A smaller fiber layer angle resulted in greater resistance to interlaminar delamination. Setting a certain number of fiber layers with angles between 0° and 45° could increase the toughness of the compression column member against interlaminar shear delamination at the initial stage. Comparisons of the experimental, numerical, and theoretical results demonstrated good agreement, indicating that the proposed theoretical method is feasible for predicting the safe bearing capacity of CARALL columns with a single-channel cross section and can be applied to the design of compressive laminate pillar components.

Axial compressive performance of laminated bamboo column with aramid fiber reinforced polymer

Axial Compression Behaviour of Bamboo-Wood Composite Columns Fabricated with Glubam and Laminated Veneer Lumber

Experimental Studies on Glubam Columns under Axial Compression

EXPERIMENTAL STUDIES OF GLUBAM COLUMNS UNDER AXIAL LOADS

Mechanical properties of aramid fiber reinforced polymer confined laminated bamboo lumber column under cyclic loading

Mechanical behavior of laminated bamboo–timber composite columns under axial compression

EXPERIMENTAL STUDY ON AXIAL COMPRESSIVE BEHAVIOR OF TIMBER COLUMN LATERALLY STRENGTHENED WITH FRP

Axial Compression Behaviours of Pultruded GFRP–Wood Composite Columns

Axial Compressive Behavior of FRP-confined Square CFST Columns Reinforced with Internal Latticed Steel Angles for Marine Structures

Experimental Study on Mechanical Properties of Bamboo Culms and Joints Reinforced with GFRP Sheets

Experimental and theoretical study on axial compression behavior of cold-formed thin-walled steel-bamboo scrimber composite columns

Influence of slenderness ratio and sectional geometry on the axial compression behavior of original bamboo columns

Effects of Cross-Section Morphology, Vascular Bundle Content and Anisotropy on Compression Failure of Laminated Bamboo Columns

Experimental-numerical study on axial compression performance of square concrete columns confined by new-type BFRP

Slenderness Ratio Effect on Eccentric Compression Properties of Parallel Bamboo Strand Lumber Columns

Experimental Study on Uniaxial Compression of Bamboo Poles with Different Reinforcements

Experimental study and numerical analysis on the axial compression performance of CFRP strip reinforced round-end aluminum alloy tube concrete column

Compressive bearing capacity and failure mechanism of CFRP–aluminum laminate column with single-channel cross section

Behaviour of CFRP strips confined partially encased concrete columns under axial compressive load

Axial Behavior of Columns with Glass Fiber-Reinforced Polymer Composite Shells and Syntactic Foam Core

Flexural Behavior of Hybrid Composite Beams with a Bamboo Layer and Lattice Ribs